Hardware Supplied
the supporting leg.
A B C D E
F G I JH
30mm screw x9
12mm screw x4
52mmscrew x6
20mmscrew x8
5mm allenkey x1
spannerx1
singlecap x24
doublecap x12
4mm allenkey x1
nutx12
Sonata Bed - King Single
1
Assembly InstructionsThank you for your purchase. Please follow the instructions below for correct assembly.
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
1 2
D
D
D
D
D
D
D
D
D
D
D
D
G
G G
G
Sonata Bed - King Single
2
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
4
3
1
2
4
3
Attach the side panels [3] & [4] to the bed head [1] as shown using 4x 20mm screws (D) and tighten with the 5mm allen key (G). Do not completely tighten the screws until the complete frame is built.
Attach the bed end [2] to the side panels [3] & [4] using 4x 20mm screws (D) and secure with the 5mm allen key (G).
3 4
B
E
H
F
E
CC
CC
E C
E
F F
H H
A
A
A
A
B
EB
E
B
E
B
E
F
Sonata Bed - King Single
3
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
23
4
5
54
3
7
6
7
1
Attach the two outer-leg supports [5] to panels [3] & [4] as shown using 4x 52mm screws (C) and 4x nuts (E). Tighten with the
spanner (H).
Attach the cross bar [6] as shown using 4x 12mm screws (A). Tighten with the 4mm allen key (F). Attach the 2x end cross bars [7] using 4x 30mm screws (B) and 4x nuts (E). Tighten with the spanner (H) and allen key (F).
5
Join the bed planks together in the middle of the frame using 12x double caps (J). Attach 24x single caps (I) onto the ends of the bed planks. Insert the planks into the bed frame using the cap ends.
I
J
I
J
I
I
IF
F
F
F
B
B
H E
B
C
C
H
E
E
B
CE
B
B
B
B
E
E
Sonata Bed - King SingleAssembly Instructions
4mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
910
8
88
97
7
Attach the ends of the long cross bar [9] with 2x 30mm screws (B) and 2x nuts (E). Secure it in the middle with the cap [10] and leg support [8] using 1x 30mm screw (B), 2x 52mm screws (C) and 2x nuts (E) and secure with allen key (F) and spanner (H). Attach the remaining two leg supports [8] with 2x 30mm screws (B). Now tighten all the screws in the completed frame.