+ All Categories
Home > Documents > Spec Gekko V5 10 2015 - Karl Deutsch Gekko V5EN.pdf · Portable PAUT for NDT cutting-edge Matrix...

Spec Gekko V5 10 2015 - Karl Deutsch Gekko V5EN.pdf · Portable PAUT for NDT cutting-edge Matrix...

Date post: 21-May-2018
Category:
Upload: lenhu
View: 215 times
Download: 0 times
Share this document with a friend
2
Real-time TFM Max number of points of reconstructed image: 62 000 Sound paths: direct, half skip, full skip Max refresh rate: 30fps Available modes: L, S and mode-converted paths 3D focusing Type of probe: matrix, sectorial, custom 2D probes 3D real-time imaging Max number of simultaneous display: 6 GUI Wizards (step-by-step guide to create dedicated app) Combo techniques (multi-salvoes) wizards Single-technique wizards: TFM, matrix, sector scan, linear scan, conventional pulse-echo, TOFD Custom & automated inspection reports Portable PAUT for NDT cutting-edge Matrix arrays . CIVA-fueled software . Real-time Total Focusing Methods (TFM). 3D imaging rugged Touch screen . Dust & water resistant . Battery operated . Hot swap user-friendly All-level operators . Application & calibration wizards . Reporting tools adaptable Custom UT made simple . Expert & opera- tor modes . 64-channel parallel . Pulse-echo . TOFD GEKKO
Transcript
Page 1: Spec Gekko V5 10 2015 - Karl Deutsch Gekko V5EN.pdf · Portable PAUT for NDT cutting-edge Matrix arrays . CIVA-fueled software . Real-time Total Focusing Methods (TFM). 3D imaging

Real-time TFM

Max number of points of reconstructed image: 62 000 Sound paths: direct, half skip, full skip

Max refresh rate: 30fps Available modes: L, S and mode-converted paths

3D focusing

Type of probe: matrix, sectorial, custom 2D probes 3D real-time imaging

Max number of simultaneous display: 6

GUI

Wizards (step-by-step guide to create dedicated app) Combo techniques (multi-salvoes) wizards

Single-technique wizards: TFM, matrix, sector scan,linear scan, conventional pulse-echo, TOFD

Custom & automated inspection reports

Portable PAUT for NDT

cutting-edgeMatrix arrays . CIVA-fueled software . Real-time Total Focusing Methods (TFM). 3D imaging

rugged Touch screen . Dust & water resistant . Battery operated . Hot swap

user-friendlyAll-level operators . Application & calibration wizards . Reporting tools

adaptableCustom UT made simple . Expert & opera-tor modes . 64-channel parallel . Pulse-echo . TOFD

GEKKO

Page 2: Spec Gekko V5 10 2015 - Karl Deutsch Gekko V5EN.pdf · Portable PAUT for NDT cutting-edge Matrix arrays . CIVA-fueled software . Real-time Total Focusing Methods (TFM). 3D imaging

GEKKOsoftware

All-level operators, application wizards, analysis, reporting Inspection modes: pulse-echo, TOFD

Real-time imaging A-Scan, B-Scan, S-Scan, C-Scan CIVA fueled phased-array calculator, compatibility with CIVA

Total Focusing Methods (TFM), images & 3D display

phased-array

Matrix and linear probes Up to 1200 delay-laws

Linear scanning, sectorial scanning Up to 6 salvos

pulsers

64 phased-array channels: 4 conventional UT channels:

Negative square pulse, width: 30ns to 1250ns Negative square pulse, width: 30ns to 1250ns

12V to 100V with 1V step 12V to 200V with 1V step

Max. PRF: 10kHz Max. PRF: 10kHz

receivers

64 phased-array channels: 4 conventional UT channels:

Input impedance: 50 Ω Input impedance: 50 Ω

Frequency range: 0.4 to 20MHz Frequency range: 0.4 to 25MHz

Max. input signal: 1.2 Vpp Max. input signal: 1.4 Vpp

TCG – ACG calibration wizard TCG – DAC calibration wizard

Gain: up to 120dB (0.1dB step) Gain: up to 120dB (0.1dB step)

Cross-talk between two channels < 50 dB

digitizer

Digitizing and real-time summation on 64 channels Resolution: 12bits, processing: 16bits

FIR filters Max. sampling frequency 100 MHz

Averaging up to 1:32 Digitizing depth up to 65000 samples

acquisition

Hardware acquisition gates, synchronization of gates Max. data flow 50 MB/s on a 128Go SSD (extensible up to 1 To)

Maximum number of acquisition gates: 6 Inspection data file size: up to 10Go

A-Scans/Peaks data recording Acquisition trigger on event (encoder)

hardware

FPGA and CPU boards 10,4‘’ touch screen – resolution 1024x768

3.5h batteries, hot swap

I-O

1 IPEX connector for phased array 4 LEMO 00 connectors for conventional UT

3 encoders input 1 external trigger*

VGA output Ethernet*

3 USB2 16 analog input*

Indicated values may change without notice. *non-handled by the software in V1.3

general

L x W x H: 410mm x 268mm x 124mm

Operating temperature range: from 0 to 40°C Weight: 6,5kg (without battery) ; 0,480g /battery

Storage temperature range: -10 to 60°C with battery IP54

© 2

015

M2M

. All

right

s re

serv

ed. G

EK

KO

is a

regi

ster

ed tr

adem

ark

of M

2M c

ompa

ny. R

ef: P

RO

_GE

KK

O_S

PE

C_V

5_E

N

M2M t. +33 (0)1 60 92 39 65 f. +33 (0)1 60 92 57 31 [email protected] w w w. m 2 m - n d t . c o m

1 rue de Terre-NeuveBât. H. Miniparc du VergerZ A C o u r t a b e u f91940 Les Ulis. France


Recommended