SPECIALISTS IN TRAINING & CONSULTANCY TO THE TECHNICAL SECURITY INDUSTRY
TelecommunicationsElectronic SecurityASIAL Training PartnerSecurity Technician CertificationTraineeshipsApprenticeships
“helping to connect and secure Australia”
T r a i n i n g C o u r s e s
1300 371 130www.comtech.edu.au
[email protected] Code: 90933
ABN: 37 106 989 235
Telecommunications Short Courses
DURATION & PRICE ONLINE OPTION5 days or 10 evenings in class (experienced technicians only) plus online content online content$800.00 (GST not applicable) plus 2 days in class $800.00 (GST not applicable)
Successful completion will provide a student with the necessary units required to apply for an Open Registration with one of the five registrars.
On successful completion, the student will receive a Statement of Attainment for the units of competency outlined below.
ACMA Cabling Registration
Cabling Endorsement CourseDURATION & PRICE ONLINE OPTION5 days or 10 evenings in class (experienced technicians only)plus online content online content plus$1200.00 (GST not applicable) 3 days in class $1200.00 (GST not applicable)
On successful completion, the student will receive a Statement of Attainment for the units of competency outlined below.
DURATION & PRICE 5 days or 10 evenings in class plus online content $1200.00 (GST not applicable) This course takes a Technician or Electrician through the technical requirements that are needed to install IP enabled devices onto an IP network.
On successful completion, the student will receive a Statement of Attainment for the units of competency outlined below.
Design & Construct an IP Network
ACMA Cabling Registration:ICTTEN202 Use hand and power toolsICTWHS204 Follow work health and safety and environmental policy and procedures ICTTEN201 Use electrical skills in telecommunications work ICTCBL236 Install, maintain and modify customer premises communications cabling: ACMA Restricted RuleICTCBL237 Install, maintain and modify customer premises communications cabling: ACMA Open Rule
Cabling Endorsement CourseICTCBL301 Install, terminate and certify structured cabling installationICTCBL302Install and terminate optical fibre cable on customer premisesICTCBL303 Install and terminate coaxial cableICTCBL304 Perform cable and system test on customer premises
Design & Construct an IP NetworkICTSAS305 Provide ICT advice to clientsICTTEN207 Install and test internet protocol devices in convergence networksICTTEN302 Install telecommunications network equipmentICTCBL306 Locate and identify cable system faultsICTSAS303 Care for computer hardware
Technical Security Short Courses
DURATION & PRICE 3 days or 6 evenings in class $800.00 (GST not applicable) This training course will take a trainee Technician or Electrician through the technical requirements that are needed to install a modern electronic security system in a domestic or small commercial application.
On successful completion, the student will receive a Statement of Attainment for the units of competency outlined below.
Alarm Installation Course
DURATION & PRICE 2 days or 4 evenings in class$550.00 (GST not applicable)
This training course has been designed and developed to take a trainee Technician or Electrician through the technical requirements that are needed to install a modern CCTV system in a commercial application.
On successful completion, the student will receive a Statement of Attainment for the unit of competency outlined below.
CCTV Installation Course
DURATION & PRICE ONLINE OPTION5 days or 10 evenings in class online content plus 1 day in class$1200.00 (GST not applicable) $800.00 (GST not applicable)
This course is also applicable for the WA Police Security Installers License.
On successful completion, the student will receive a Statement of Attainment for the units of competency outlined below.
Combined Alarm and CCTV Course
Alarm InstallationCPPSEC2021AInstall security equipment and systemsCPPSEC2026APerform routine maintenance on security equipment and system
CCTV InstallationCPPSEC2023A Install CCTV equipment and systems
Advanced CCTV - Design and Construct CourseDURATION & PRICE 2 days $900.00 (plus GST)
This is an ideal course for designers and managers of large scale CCTV networks especially those involved with developing CCTV assets for local Government.
The advanced CCTV design and construct course is a two day workshop on designing IP CCTV systems for wide area deployment through an IP infrastructure.
ASIAL Security Technician Certification (STC)
The Australian Security Industry Association Ltd (ASIAL), in conjunction with Comtech Training, is delivering the Security Technician Certification (STC) training program nationally.
Designed to provide a career pathway for security technicians, the Security Technician Certification program is also a proactive initiative to attract and retain appropriately skilled workers, capable of meeting the future needs of the industry.
What is the program?
The Security Technician Certification program is a nationally recognised program initiated by ASIAL to recognise technicians who have relevant industry experience and training. This will become the benchmark for electronic security training in Australia.
How is the program delivered?
The program is delivered through a combination of self-paced study and online assessments.
• The technician registers for the STC program via the ASIAL or Comtech website and then selects the course from the links provided
• Once the technician has been approved and pays the appropriate fee, they can log onto the online portal to start their training
• Once the technician has completed all units, they will receive a Statement of Completion
The Security Technician Certification program covers:
• Cabling Practices• Alarms• CCTV• Access Control• IP Networking for the Security Professional• Cyber Security
The Security Technician Certification program incorporates three levels of recognition:
1. Certified Security Technician (CST)2. Advanced Security Technician (AST)3. Master Security Technician (MST)
Please refer to our website www.comtech.edu.au for more information on the STC Program.
Scan here for more information on the STC Program
ASIAL Security Technician Certification (STC)
Level 1 – Certified Security Technician
Course content
1. Installation Practices2. Intruder Alarm Systems3. CCTV Systems 4. IP Networking for the Security Industry
The program is delivered through a combination of self-paced study and online assessments
Level 2 – Advanced Security Technician
Course content
1. Advanced IP Networking2. Wireless Networks3. Introduction to Cyber Security4. CCTV Advanced (Design) 5. Access Control Systems
The program is delivered through a combination of self-paced study and online assessments
Level 3 – Master Security Technician
Course content The Master Security Technician qualification is based on demonstrated knowledge and experience.It is the highest ASIAL Award and recognises industry participation and excellence.
Please refer to our website www.comtech.edu.au for more information on the STC Program.
Prerequisites
1. Open Registration2. White card
Cost $250.00 (plus GST)
Prerequisites 1. Level 1 completed2. Individual Security License3. Cabling endorsements
Cost $600.00 (plus GST)
Prerequisites 1. Level 1 and Level 2 completed2. Individual Security License3. Individual ASIAL Membership
Cost $250.00 (plus GST)
Additional online courses available:
Intruder Alarms Design course for sales professionals $250.00 (plus GST)CCTV Course Design course for sales professionals $250.00 (plus GST)Advanced CCTV Design course for wide area deployment $250.00 (plus GST)IP Networking For the security professional $100.00 (plus GST)Optical Fibre Introduction to optical fibre systems $100.00 (plus GST)Structured Cabling Introduction to structured cabling $100.00 (plus GST)
Qualifications
Introduction to Technical SecurityCourse Units
1. CPPSEC2001A Communicate effectively in the security industry2. CPPSEC2002A Follow workplace safety procedures in the security industry3. CPPSEC2003B Work effectively in the security industry4. CPPSEC2020A Provide technical security services to clients
Duration: Online plus 1 day face-to-face workshop Cost: $400.00 (GST not applicable)
Alarm and CCTV Installation CourseCourse Units
1. CPPSEC2021A Install security equipment and systems2. CPPSEC2026A Perform routine maintenance on security equipment and system3. CPPSEC2023A Install CCTV equipment and system
Duration: 5 days or 10 evenings Cost: $1200.00 (GST not applicable)
Cabling Registration - (Open Cabling Registration)Course Units (required by industry)
1. ICTTEN202 Use hand and power tools2. ICTWHS204 Follow work health and safety and environmental policy and procedures 3. ICTTEN201 Use electrical skills in telecommunications work4. ICTCBL236 Install, maintain and modify customer premises communications cabling:
ACMA Restricted Rule5. ICTCBL237 Install, maintain and modify customer premises communications cabling:
ACMA Open Rule
Duration: Online plus 5 days or 10 evenings Cost: $800.00 (GST not applicable)
Qualification Cost
Total if booked as individual courses $2400.00 (GST not applicable)Total if booked as a full qualification $2200.00 (GST not applicable)
Please refer to our website www.comtech.edu.au for more information on the above qualification.
CPP20307 - Certificate II in Technical SecurityQualification OutlineThis nationally recognised qualification is designed to give an individual who wishes to work in the security industry at a technical level, the skills and knowledge required to competently install an intruder alarm system or CCTV system in a residential or commercial building.
This qualification is made up of three Comtech courses:
Qualifications
Apprenticeships and Traineeships in the Security Industry
Both of the below qualifications are ideal for new entrants, or for experienced technicians who want to upskill to take advantage of new and emerging technologies in the Telecommunications or Electronic Security industries.
UEE30411 - Certificate III in Data and Voice Communications
This apprenticeship is comprised of a number of short courses delivered over a period of 18-48 months incorporating in class face to face training, online content and on the job training.
This qualification incorporates the following:
Basic Electronics Design and Construct IP NetworksWHS Intruder Alarm SystemsOpen Cabling Registration CCTV SystemsCombined Endorsement Design and Construct a Wireless Network
Cost $5600.00 (No GST) Government funding is available for this course (terms and conditions apply)
ICT30515 - Certificate III in Telecommunications Technology
This traineeship is comprised of a number of short courses delivered over a period of 12-24 months incorporating in class face to face training, online content and on the job training.
This qualification incorporates the following:
Open Cabling Registration Combined Endorsement Design and Construct IP Networks
Cost: $4000.00 (No GST) Government funding is available for this course (terms and conditions apply)
What’s the difference between a traineeship and an apprenticeship?
The fundamental difference is the content and therefore the duration. In this case the apprenticeship is designed to take a technician through all the technical requirements of both the telecommunications and technical security industry, whereas, the traineeship allows a trainee to pick some key components more applicable to their respective job role.
Our Training Advisors are industry specialists and can advise and support the decision making process on which qualification is more applicable for your employees.
Please refer to our website www.comtech.edu.au for more information on the above qualifications.
Comtech Training - “helping to connect and secure Australia”
RTO Code: 90933 ABN 37 106 989 235
A division of Ramsden Telecommunications Training PTY LTD CD 16/07-18 R1.0
Our locations are as follows: WA, Welshpool Centre WA, Adams Drive Centre 223 Star Street 3/30 - 34 Adams DriveWelshpool, WA 6106 Welshpool, WA 6106Tel: 08 9355 5770 Tel: 08 9355 5770
NSW, Homebush Centre NSW, Newcastle Centre6/7 - 9 Underwood Road Suite 7, 115 Griffiths RoadHomebush, NSW 2140 Lambton, NSW 2299Tel: 02 9897 0000 Tel: 1300 371 130 VIC, Port Melbourne Centre 200 Lorimer StreetPort Melbourne, VIC 3207Tel: 03 9948 0410 QLD, Salisbury Centre Comtech Training, Building 4Construction Training Centre460 - 492 Beaudesert RoadSalisbury, QLD 4107Tel: 07 3338 5500
SA, Regency Park CentreConstruction Industry Training Centre (CITC) 491 - 499 South Road Regency Park, SA 5010 Tel: 1300 371 130
RTO Code: 90933ABN: 37 106 989 235ACN: 106 989 235
Website: www.comtech.edu.auEmail: [email protected]
National Tel: 1300 371 130
Contact us
