SPECIFICATIONSInput Voltage: 220-240V~50HzMotor: 1200WMax. Flow Rate: 23,000l/hMax. Lift: 3mMax. Head: 16m Max Particle Size: 2.5mm Water Temperature: 1 °C - 35 °CInlet & Outlet: 57mm (2-1/4”)Coupling: Suits 40mm PVC Pressure Pipe Max. Pressure: 2.25 bar Working Pressure: 1.5 bar IP Rating: IPX4Weight: 12kg
1. Suction Inlet
2. Inlet Coupling
3. Transparent Filter Cover
4. Discharge Outlet
5. Pump Housing
6. Motor
7. Filter Drain Plug
8. Filter Basket
9. Outlet Coupling
10. Mounting Holes
11. Pump Drain Plug
12. Elevated Base
SUBMERSIBLE PUMP
11 1210987
654321
Suction line(Inlet)
Pool return line(Outlet)
Pool
FilterMust suit
1.5 HP(or greater
pump)Heater(if fitted)
POSSIBLE FAULTS CAUSES
Air leak Verify sealing of connectors and seals
Bad sealing filter cover Clean the filter cover and verify the seals
Excessive suction height Set pump at a suitable level
Incorrect voltage Verify the voltage specified on the rating label and that of the mains power
No water in prefilter Fill prefilter with water
Filter clogged Clean filter
Discharge clogged Inspect filter and discharge line
Incorrect pump attachment Attach pump correctly
Debris in filter basket Clean pump and inspect the filter
sesuf eht teseRrewop oN
Motor blocked Call Ozito Customer Service
SOLUTIONS1 2 3 4 5
X
X
X
X X X
X
X
X
X
X
X
X
X
X
X
Possible faults1. Pump does not prime2. Low flow rate3. Pump makes loud noise4. Pump does not start5. Motor makes noise but does not start pumping water
Suction line(Inlet)
Pool return line(Outlet)
Pool
FilterMust suit
1.5 HP(or greater
pump)Heater(if fitted)
V Volts Hz Hertz
~ Alternating current W Watts
/min Revolutions or no No load speed reciprocation per minute
l Litres ºC Degrees celsius
p/hr Per hour kPa Pressure rating (kilopascals)
bar Pressure rating F Insulation class
PVC Polyvinyl chloride IPX4 Ingress protection from water
Regulator compliance mark Warning
Read instruction manual
SPARE PARTS Tool: Model No.
Item No. Description Part No.
How To Order
51123
Available spare parts can be ordered through the Special Orders Desk at any Bunnings Warehouse. If you have any further questions, please contact Ozito Customer Service on:Australia: 1800 069 486New Zealand: 0508 069 [email protected]
The following is a list of spare parts carried by Ozito. Please contact Customer Service for any parts not listed.
Tool
: 120
0W P
ool P
ump
Mod
el N
o. S
WP
P-1
200
Item No. Description Part No.