ORGANICS2.45 YD AND 3 YD STEEL FEL CONTAINERS
ORGANICS STEEL FEL CONTAINER
2GOOrganics
Collect • Store • TransportPart of
Cost eff ective and environmentallyresponsible
•Fully nestable when unassembled
The Organics Steel FEL Container features a heavy duty, reinforced lid and body for handling heavy, wet organic waste.
Improves safety
•Durable, single-piece lid with trap door keeps out insects, rodents and animals
•Trap door provides easy access
•Continuous lip on lid traps odors and prevents leakage
•Locking lid prevents unauthorized access
Durable
•Fully welded inside seams
•100% water tested
•Fully welded pockets at critical stress points reduce fork damage and ensure long service life
•Floor channels are capped at both ends to prevent debris from getting inside
•Interlocking top channel frame provides added strengthEasy to use
•Easy to maneuver with casters
•Compatible with front end load forks for easy pickup and dumping
BENEFITS
Wastequip is the leading North American manufacturer of waste and recycling equipment for collecting, processing and transporting recyclables and solid or liquid waste. October 2011 © Wastequip, all rights reserved. Specifications subject to improvement without notice. Equipment displayed should be operated by properly trained personnel. Operators should become familiar with OSHA, ANSI and any other applicable standards or laws for using this equipment. Improper use, misuse, or lack of maintenance could cause injury to people and/or property. Photos used in the literature are illustrative only. We assume no liability or responsibility for proper training/operation of equipment not manufactured by Wastequip. We reserve the right to make changes at any time without notice. Information contained within this literature is intended to be the most accurate available at time of printing.
ORGANICS STEEL FEL CONTAINER
Tel: 877.468.9278 | [email protected] | www.wastequip.com
SPECIFICATIONS
•10 ga. bottom with (2) formed 4” high x 3” wide x 10 ga. channels with caps on each end
•12 ga. front, back and end sheets
•10 ga. formed “G” Channels on front and rear – continuously welded around the top perimeter
•12 ga. formed “G” Channels on front and rear – continuously welded around the top perimeter
•Hinge brackets – stamped 7 ga.
•Lifting sleeves – formed 10 ga. channels x 24” long
•Blunderbuss – formed 7 ga.
•Top sleeve gusset – 12 ga.
•(2) Taco gussets welded to the bottom of the lifting sleeves
•Flame cut – 3/8” chain hook plates continuously welded to the lower portion of the lifting sleeves
•Manual locking bar with chain for dual lock operation (pad locks not included)
•Special organic toter poly lid with hatch door & opening within the lid
•Hinge rod – 5/8” diameter galvanized
•Special interior coating – 12 mils dft of catalyzed coating system applied to the interior including the top of the top framing
•Exterior is primed with alkyd primer and top coated with alkyd industrial enamel – color per customer’s selection
•Weight: 2.45 Yard = 560 lbs 3 Yard = 630 lbs
������
��������������������������������
���������� ���������
�������������
��������������������������������������������������������������������������
�����������������������������������������������������
���������
������
��������������������������������
����������
��������������������������������������������������������������������������
�����������������������������������������������������
�����������������������������������������������������������������������������������������������������������������������������������������������������
48 5/16
46 1
1/16
54 7/8
42
2.45 and 3 Yard Containers 2.45 Yard Container 3 Yard Container
WQP047-102011