Date post: | 17-Jan-2016 |
Category: |
Documents |
Upload: | archibald-jordan |
View: | 219 times |
Download: | 0 times |
Steps To Configure One Sensor
Gary Tipton
The Hardware:
Retro-reflective Photo Sensor
Actual Sensor
Device Box
To Configure the sensor:
Open up RS Logix software and select Device Net.
Perform a scan of the system to see if the system recognizes any items in it’s network.
After the device has been observed by the master, than a new address could be assigned to the device.
A better look:
Screen shot
A New Address:
Right click on the device that you want to give a new address to.
Select properties The device information can be manipulated
from there. Re-scan to ensure the new address takes
Properties
Name and Address
Re-Scan