Date post: | 07-Jul-2018 |
Category: |
Documents |
Upload: | alexandre-da-silva-pinto |
View: | 231 times |
Download: | 0 times |
of 4
8/18/2019 Suzuki Swift 16
1/4
ECU : Suzuki Swift 1.6
Connect as below:
Serial Suite: ECU Plug:
Red to 2 Pins Red (Power Supply +12 Volt)Black to 2 Pins Black (Ground)
Piasiniengineering [email protected] – http://www.piasiniengineering.itTel: +39 0342 489060 - Fax: +39 0342 488298
mailto:[email protected]://www.piasiniengineering.it/http://www.piasiniengineering.it/mailto:[email protected]
8/18/2019 Suzuki Swift 16
2/4
Where to connect the flat cable:
Piasiniengineering [email protected] – http://www.piasiniengineering.itTel: +39 0342 489060 - Fax: +39 0342 488298
mailto:[email protected]://www.piasiniengineering.it/http://www.piasiniengineering.it/mailto:[email protected]
8/18/2019 Suzuki Swift 16
3/4
RE D the ECU:
1. Connect the flat cable pin following the number like in picture;2. Put a RESISTOR (1KOhm) like in the picture;3. Put a wire (bridge) like in the picture
Piasiniengineering [email protected] – http://www.piasiniengineering.itTel: +39 0342 489060 - Fax: +39 0342 488298
mailto:[email protected]://www.piasiniengineering.it/http://www.piasiniengineering.it/mailto:[email protected]
8/18/2019 Suzuki Swift 16
4/4
WRITE the ECU:
You have to remove the bridge used before
, and put another 2 wire(Bridge) like in thepicture.
Piasiniengineering [email protected] – http://www.piasiniengineering.itTel: +39 0342 489060 - Fax: +39 0342 488298
mailto:[email protected]://www.piasiniengineering.it/http://www.piasiniengineering.it/mailto:[email protected]