Pump and Abrasion Technologies® (Pty) Ltd. Australia ABN: 62 617 704 43510 Remisko Drive, Forrestdale, WA, 6112Perth, Western AustraliaTel: +61 (08) 9707 2682 | Email: [email protected]
TAILINGS APPLICATIONS
Pump & Abrasion Technologies® newly designed CURVE range of slurry pumps have been proven to surpass life cycle expectancies while reducing the Total Ownership Costs (TOC) of the pumping solution.We have experienced positive results where our CURVE range pumps are installed in Long distance slurry transportation application. These include but are not limited to tailings and hydro mining applications where our pumps are connected either in close proximity or staggered over the length of the pipeline.
TOC REDUCTION• Total Ownership Cost reduction due to optimised capex and opex pumping
package. (Between 40% and 60% TOC saving)• Reduced down time during maintenance intervals (up to 80% reduction)
LONGER WEAR LIFE• Longer time between maintenance intervals
• Optimised wear material distribution• Significantly reduced sealing maintenance due to Hi-Cr shaft sleeve and lantern ring
IMPROVED EFFICIENCY• Matched impeller inlet profiles for optimum wear
• Matched shroud and impeller faces for reduced recirculation• Higher efficiency vane profile
LOWER POWER CONSUMPTION THROUGHOUT THE LIFE CYCLE• Improved low profiles reduces wear rate and maintain efficiency through out operational life
