The re-positioned ground pad is in the right place.

Multiple ground tracers(see slide 2)

But:

MultipleGround tracers

Different levels for tracers because of different heights of the anchor pads

Multiple ground tracers caused by different heights of anchor pads

Anchor andtracer beam arenot joined

As the anchoris displaced downward,the beamdoes not follow

This beam is not tracer.I am not sure of why it is required though

This beam is tracer – and this follows anchor

Anchor edge and p0 edge don’t exactly line up

I increased the size (width , along x-axis)

of p0 such that it goes beyond anchor

Anchor Displaces out of P0 box

I am not able to fix this. This has to do with changing l, L1, L2 of line 64 of latest netlist. But I am not sure of how these parameters are computed

Different end points, not constrained to join the anchor.

In the absence of the tracers

When the number of fingers is used as a parameter, it no longer spaces the comb drives out correctly in x. When the starting number of fingers is less than 10, the layout converter hangs, and no gds file is created.

This should be fixed if the files that I sent are updated