+ All Categories
Home > Documents > THE SPIDER SYSTEM For Installation of Overhead … involves much tying and untying while the pulling...

THE SPIDER SYSTEM For Installation of Overhead … involves much tying and untying while the pulling...

Date post: 30-May-2018
Category:
Upload: vannhi
View: 220 times
Download: 2 times
Share this document with a friend
4
HI-LINE UTILITY SUPPLY CO. Phone: 800-323-6606 Fax: 847-488-1285 www.hilineco.com THE SPIDER ® SYSTEM For Installation of Overhead Pulling Lines The conventional method of installing a pulling line requires hanging "finger lines" at each pole. This involves much tying and untying while the pulling lines are "walked" through. Not only is extra labor involved, but the finger lines are left dangling and subject to overnight vandalism. Spider System eliminates finger lines, vandalism, and extra climbs Consists of a positive braking controller and a storage reel of rope that mount on the lead pole at any desired height. Once the controllers and storage reels are mounted on the lead pole, the lineman takes the pilot lines up with him and lays them in the stringing blocks as he frames the pole. After these lines are pulled out, they can be tied off under tension and left until time for stringing the conductor. When the pulling lines is ready to be installed, the same storage reel can be mounted on either a pole-mounted winch or on a line truck winch. Spider System Kit Includes: Pole Mount Controller (Cat. No. S-75-C) Storage Reel (Cat. No. S-75-SR) Rope (two lengths available) Cat. No. S-75-C Can be mounted on wood poles with a simple lag screw or on non-wood poles with the adjustable chain tightener. The brake on the controller permits the storage reel to pay out the pilot line when the rope is pulled and engages when the rope is slack. This eliminates "backwinding" and holds tension during the installation of the pilot line. Cat. No. S-75-WA Can be used with a line truck winch and an S-7500 Spider® reel to take up Spider® rope instead of using a puller outfitted with a hydraulic Spider® rewind. Manufactured out of steel and CNC precision machined for a more precise fit, this newer version has less "slop and lope" when pulling in the Spiderflex rope! 221 ROPE & WINCH LINES Rope & Winch Lines Cat. No. Description S-7500 Kit with 3,000' of rope S-8500 Kit with 6,000' of rope To create the Spider System set-up shown above, (4) kits are required. WINCH SHAFT ADAPTER POLE MOUNT CONTROLLER
Transcript
Page 1: THE SPIDER SYSTEM For Installation of Overhead … involves much tying and untying while the pulling lines are "walked" through. Not only is extra labor involved, but the finger lines

HI-LINE UTILITY SUPPLY CO.Phone: 800-323-6606 Fax: 847-488-1285 www.hilineco.com

THE SPIDER® SYSTEMFor Installation of Overhead Pulling Lines

The conventional method of installing a pulling line requires hanging "finger lines" at each pole. This involves much tying and untying while the pulling lines are "walked" through. Not only is extra labor involved, but the finger lines are left dangling and subject to overnight vandalism.

• Spider System eliminates finger lines, vandalism, and extra climbs

• Consists of a positive braking controller and a storage reel of rope that mount on the lead pole at any desired height.

• Once the controllers and storage reels are mounted on the lead pole, the lineman takes the pilot lines up with him and lays them in the stringing blocks as he frames the pole. After these lines are pulled out, they can be tied off under tension and left until time for stringing the conductor.

• When the pulling lines is ready to be installed, the same storage reel can be mounted on either a pole-mounted winch or on a line truck winch.

Spider System Kit Includes:• Pole Mount Controller (Cat. No. S-75-C)• Storage Reel (Cat. No. S-75-SR) • Rope (two lengths available)

Cat. No. S-75-C Can be mounted on wood poles with a simple lag screw or on non-wood poles with the adjustable chain tightener. The brake on the controller permits the storage reel to pay out the pilot line when the rope is pulled and engages when the rope is slack. This eliminates "backwinding" and holds tension during the installation of the pilot line.

Cat. No. S-75-WA Can be used with a line truck winch and an S-7500 Spider® reel to take up Spider® rope instead of using a puller outfitted with a hydraulic Spider® rewind. Manufactured out of steel and CNC precision machined for a more precise fit, this newer version has less "slop and lope" when pulling in the Spiderflex rope!

221

ROPE & WINCH LINESR

ope & W

inch Lines

Cat. No. DescriptionS-7500 Kit with 3,000' of ropeS-8500 Kit with 6,000' of rope

To create the Spider System set-up shown above, (4) kits are required.

WINCH SHAFT ADAPTERPOLE MOUNT CONTROLLER

Page 2: THE SPIDER SYSTEM For Installation of Overhead … involves much tying and untying while the pulling lines are "walked" through. Not only is extra labor involved, but the finger lines

ROPE & WINCH LINESR

ope

& W

inch

Lin

es

3-STRAND TWISTED ROPE

STANDARD LENGTHS: 600' & 1200'OTHERS AVAILABLE UPON REQUEST

• Yellow 3-strand twisted rope made from 100% monofilament polypropylene yarns.

• Spliceable rope with good dielectric properties at an economical price.

• Polypropylene is stronger and lighter than Manila and can be stored wet without fiber damage.

POLY-PRO ROPE

• This 3-strand twisted rope is white with a red tracer.• Combination of polyester and polyolefin yarns.• Polyester jacket gives good abrasion resistance,

ultraviolet resistance, knot-holding qualities, and a good hand.

• Polyolefin yarns afford better dielectric properties and a lighter weight.

(Uses: Stringing, Pulling, Handline)

HANDLINE SETSHandline Set with

Alum. BlockHandline Set with

Nylon Block Dimensions*

HSJ08HP-75 HSN08HP-75 1/2" x 75' HSJ08HP-100 HSN08HP-100 1/2" x 100'HSJ08HP-125 HSN08HP-125 1/2" x 125'HSJ08HP-150 HSN08HP-150 1/2" x 150'HSJ10HP-75 HSN10HP-75 5/8" x 75'HSJ10HP-100 HSN10HP-100 5/8" x 100'HSJ10HP-125 HSN10HP-125 5/8" x 125'HSJ10HP-150 HSN10HP-150 5/8" x 150'*Dimensions provided are actual length, not the lift length.

Example: A 100' handline set provides 50' of lift.

Handline Set comes with:• 1/2" or 5/8" hi-power three strand rope• (1) 303J Aluminum Block or (1) 3550 Nylon Block• (1) HL1 Double Eye Hook spliced on one end• (1) 470 Snap spliced on other end

HI POWER ROPE

Cat. No. Dia. Working Load

Approx Avg Tensile

Approx Weight per CFT

HP06 3/8" 275 lb 2,750 lb 3.6 lbHP08 1/2" 555 lb 5,000 lb 6.5 lbHP10 5/8" 880 lb 7,040 lb 9.5 lbHP12 3/4" 1,400 lb 9,800 lb 12.5 lbHP16 1" 2,000 lb 14,000 lb 21.8 lb

Cat. No. Dia. Working Load

Approx Avg Tensile

Approx Weight per CFT

PP04 1/4" 113 lb 1,130 lb 1.2 lbPP06 3/8" 244 lb 2,440 lb 2.8 lbPP08 1/2" 420 lb 3,780 lb 4.7 lbPP10 5/8" 700 lb 5,600 lb 7.5 lbPP12 3/4" 1,090 lb 7,650 lb 10.7 lbPP16 1" 2,000 lb 12,600 lb 18 lb

ADDITIONAL HANDLINE BLOCKS AND ACCESSORIES AVAILABLE

(PAGE 192)

Handline Set with Alum. Block

222HI-LINE UTILITY SUPPLY CO.Phone: 800-323-6606 Fax: 847-488-1285 www.hilineco.com

Page 3: THE SPIDER SYSTEM For Installation of Overhead … involves much tying and untying while the pulling lines are "walked" through. Not only is extra labor involved, but the finger lines

HI-LINE UTILITY SUPPLY CO.Phone: 800-323-6606 Fax: 847-488-1285 www.hilineco.com

ROPE & WINCH LINES

223

ROPE & WINCH LINES

ESTERPLEX (Tenex, Yalex)

WINCH LINE HOOKS

Please specify the following when ordering:• Type of rope (Rhino-Flex

is recommended for most applications)

• Diameter of rope• Number of eyes to be

spliced• Size of Eyes (3” eyes are

standard)• Finished length of winch

line (ft)

• Uses: Winch Lines, Stringing Lines• Parallel Braid/Aligned construction of

100% high tenacity polyester jacket and core combined to provide low stretch and high strength.

• Braid over braid construction gives a torque-free rope.

• Resistant to ultraviolet degradation and suited for prolonged outdoor exposure.

• Good dielectric properties with low stretch and high strength.

RHINO-FLEX (Stable Braid, Double sterlon)

• Uses: Stringing, Pulling, Handline• 12-strand 100% high tenacity polyester

single braid construction offering high strength and low stretch.

• The line is easily spliced with standard hollow braid splicing methods.

• Use where a high strength and low stretch line is needed.

Rope &

Winch Lines

BRAIDED ROPE

CUSTOM WINCH LINES

Cat. No. DescriptionS3319-15 2.6 ton, for 9/16"-5/8" synthetic ropeS3319-25 2.5 ton, for 3/4" - 13/16" synthetic ropeS3319-45 4.5 ton, for 7/8" - 1" synthetic ropeWinch Line Hook comes with protective spool & shield

Cat. No. HL(rope dia)-6CS6' Cordura wear sleeve

Cat. No. NE(rope dia)Bronze rope eye thimble

Cat. No. Dia. Working Load

Approx Avg Tensile

Approx Weight per CFT

EP06 3/8" 955 lb 6,200 lb 4.5 lbEP08 1/2" 1,915 lb 11,500 lb 9.0 lbEP10 5/8" 3,000 lb 16,500 lb 13.5 lbEP12 3/4" 4,000 lb 22,000 lb 18 lb

Cat. No. Dia. Bronze Thimble

Working Load

Approx Avg Tensile

Approx Weight per CFT

RF06 3/8" NE06 845 lb 5,500 lb 4.7 lbRF08 1/2" NE08 1,635 lb 9,800 lb 8.3 lbRF10 5/8" NE10 2,820 lb 15,500 lb 13.3 lbRF12 3/4" NE12 3,455 lb 19,000 lb 17.2 lbRF14 7/8" NE14 5,900 lb 29,500 lb 26.7 lbRF16 1" NE16 7,200 lb 36,000 lb 34.4 lb

Custom Winch Lines

Cat. No. 50061This rope snatch block with an inte-grated friction bar is used for lower-ing loads, snubbing loads, and raising loads. When lowering loads, tension is transferred from the worker to the block and provides greater control.

OX BLOCK

Page 4: THE SPIDER SYSTEM For Installation of Overhead … involves much tying and untying while the pulling lines are "walked" through. Not only is extra labor involved, but the finger lines

(Uses: Pulling Fiber Optic cable in duct or conduit)

Braided Polyethylene over Polyester rope. Unique construction combines a small diameter, high strength rope with these additional features:

• Non-twist• Low stretch• Easy splice• Slick finish to ease pulls

Kit Includes:• (1) Bridger™ Shoulder Line

Gun with aluminum line canister

• (1) Pelican™ Case, sturdy wheels, multiple handles (one retractable), waterproof w/lifetime warranty

• (10) Solid brass projectiles• (4) 950’-70 lb test orange nylon shot lines• (2) 780’ - 140 lb test orange nylon shot lines• (3) Rewinding spindles• (50) Blank cartridges – heavy load W/MSDS

(optional: 20 Heavy, 20 Light & 2 extra projectiles)

• (1) Plastic 50 round ammo case with handle and flip-top

• (1) Gun oil, cleaning solvent, cleaning rod, wire brush & patches

• (1) Bore snake for fast cleaning in the field• (1) Gun lock• (1) Instructions

Line Gun Kit can be customized to your needs.

Ready for use in seconds. Just squeeze the trigger and your pull line is there!

Line Gun can bridge distances up to 750’ depending on line weight, cartridge load and wind conditions.

Cat. No. Dia.Standard Tensile

(lbs)

Min. Tensile

(lbs)

Approx. Density

(lbs/100’)NY06 3/8" 3600 lb 3240 lb 3.0NY08 1/2" 6300 lb 5670 lb 5.3NY10 5/8" 9900 lb 8910 lb 8.6NY12 3/4" 14,200 lb 12,780 lb 12.3

3-STRAND NYLON ROPE

LINE GUN KIT

Cat. No. CG85DU

Cat. No. SP

16 oz. "shot pouch" is ready to attach to any hand line.

THROWING WEIGHT

Shoots throw bag and line through tree limbs, delivering line up to 200’. Use with two 4’ extension poles or one 4’ and one 6’ extension pole.

Cat. No. DescriptionBS-1 Big Shot

BS-CC Carrying Case

FG-BS-KIT1Big Shot Kit

(includes Big Shot, 4' Extension Pole, & 4' Base Pole)

BIG SHOT

SLICK-ROPE

Cat. No. Dia x Length Avg Tensile StrengthSL9/32-5000 9/32" x 5000' 1,800 lb

Rop

e &

Win

ch L

ines

ROPE & WINCH LINES

224HI-LINE UTILITY SUPPLY CO.Phone: 800-323-6606 Fax: 847-488-1285 www.hilineco.com


Recommended