THERMAL HEAT TREATMENT SOLUTIONS
THERMAL HEAT TREATMENT SOLUTIONS for
Advanced Ceramics & Composite Materials
• Privately owned and formed in 1983
• Based in Stoke-on-Trent, England
• Accredited to ISO 9001/2008.
• 50 people employed throughout the company covering:-
o Design
o Engineering
o Fabrication & Installation
o Commissioning
o Sales
• Annual Group Turnover in excess of £10 million.
• Global offices in:-
o USA, Malaysia, Thailand, China & India.
COMPANY OVERVIEW
• Flexibility of contract structure,
from small scale engineering
design to full “turnkey”
packages
• Complete installation and
commissioning service.
• After sales service from the UK
CAPABILITIES
• Design, consultation and feasibility study.
• Research & Development facilities at the Head Office
• Independently validated by::-
CAPABILITIES
• Unlike conventional dryers that use heated air as the drying medium, the R-O2
drying process developed by CDS, uses dry superheated steam at
atmospheric pressure.
• The process can be adapted for all production rates, with large scale plant
capacities being possible as no maximum “scale up” barriers have been
identified.
R-02 DRYING PRINCIPLE
• Save up to 50% of drying energy cost.
• Reduced drying times in all production process.
• Higher heat carrying capacity of ‘dry’ superheated steam used to dry the product.
• Lower viscosity enables deeper and faster permeation of the heat into dense products
• Batch or continuous drying process
• Uniform & accurate temperature / humidity & airflow control on all processes.
• Sterile environments.
• Extremely efficient thermal systems.
• Incredibly low maintenance.
R-02 DRYING TECHNOLOGY
R-O2 DRYING for ADVANCED CERAMICS
Ceramic crucible
Ceramic Components A CDS R-O2 Dryer for Ceramic Crucible and Components
R-O2 DRYING for ADVANCED CERAMICS
A series of five (5) CDS R-O2 Dryers for extruded Honeycomb Ceramic catalysts
R-O2 DRYER UNDER CONSTRUCTION
R-O2 DRYING for ADVANCED CERAMICS
A CDS R-O2 Dryer for wet cast refractory blocks, shapes, bricks & monolithics
THERMAL HEAT TREATMENT UNITS
• Reduced energy cost & extremely efficient thermal systems.
• Reduced cycle times in all production process.
• Batch or continuous systems
• Uniform & accurate temperature / humidity & airflow control on all
processes, where required.
• Variety of construction materials and operating temperatures to suit
all applications.
• Industries:-
• Aerospace, Automotive, Defence, Medical, Electrical, Foundry
• Typical Applications:-
o Curing, Ovens, Baking, Paint Stoving, Drying, Drum Heating
• Typical Products:-
• Composites, Concrete, Glass fibre, Ceramics, Paints, Polymers
THERMAL HEAT TREATMENT UNITS
A CDS Thermal Heat Treatment System for Concrete/Ceramic Composites.
THERMAL HEAT TREATMENT UNITS
A CDS Thermal Heat Treatment System for Electrical cable
THERMAL HEAT TREATMENT UNITS
A series of CDS Thermal Heat Treatment Systems for Ceramic Baking
THERMAL HEAT TREATMENT UNITS
A series of CDS Thermal Heat Treatment Systems for Carbon Composites.
• Tel: +44 (0) 1782 336666
• Fax: +44 (0) 1782 599279
• Contacts: Steve Birch, Neil Harrison,
Lucas Dunne or Terry Dunne
• Email: [email protected]
• Website: www.cds-group.co.uk
• Address: CDS Group Cinderhill Trading Estate, Longton, Stoke-on-Trent, Staffordshire, United Kingdom. ST3 5JU.