Date post: | 26-Mar-2015 |
Category: |
Documents |
Upload: | paige-pugh |
View: | 237 times |
Download: | 3 times |
Thule Smart RV™ Pod Kit InstallationFor Smooth-Sided Fiberglass RVs
After reviewing all potential interior
and exterior wall obstructions, locate
the Pod mounting line by using a stud
finder.
Turn off all utilities.
Step 1
Using a straight edge or chalk line,
mark a Pod mounting line.
Note: Pod spacing is determined by
the accessory being mounted.
Some accessories will require 16”
spacing, some accessories will require
12” spacing, some accessories will
require no spacing (single pod).
Step 2
Using the provided template, mark the
first Pod location with a bulls eye.
Hold the template to the mounting
spot, and punch the four starter holes
with a center punch.
Step 3
Be careful to only drill into the outer
section of the smooth fiberglass wall!
Drill the small vertical pilot holes for the
backing plate using a 1/16” drill bit.
Drill the large horizontal holes for the
pod using the 3/8” drill bit.
Tip: We recommend applying masking tape to the drill bits to mark the desired depth and to prevent drilling too deep.
Step 4
Prepare the mounting area by lightly
sanding the fiberglass between the
drilled holes, as shown.
Clean the surface of the wall.
Step 5
Apply a thin coat of the waterproof
adhesive (provided) onto the inside
area of the backing plate. Spread
evenly to ensure complete coverage.
Step 6
Insert backing plate into the holes. If
necessary, lightly tap the backing plate
with a rubber mallet to ensure that the
plate is flush against the RV wall.
Wipe off any excess adhesive with a
paper towel.
Step 7
Reinforce plate with the two small #6 x
½” screws. These are set screws
and prevent the backing plate from
moving while the adhesive cures and
sets prior to the installation of the pod.
Step 8
Attach the Pod assembly onto the
backing plate using the larger ¼”- 20
screws after the Pod adhesive has
cured completely (24-48 hours).
Step 9
Finished!
The SMART RV accessories can now be safely mounted.
When Pods are not is use, you can cover the Pods with the Pod covers, included.