Time Machine TM3 Johann

instructions for unpacking & installing

Open the box and take out the accessories and the upper card- boards.

Unpacking the Time Machine TM3

Carefully remove the cardboard containing the pendulum and put it aside.

Fabrical GmbH · Florian Schlumpf Swiss Timemaker Sihlbruggstrasse 117 · 6340 Baar · Phone (0)78 613 19 16 · www.schlumpf.swiss

Take the Time Machine out of the box.

Carefully remove the Time Machine by simultaneously pull-ing the rope and the lower part of the machine upwards and place it on an even ground.

Fabrical GmbH · Florian Schlumpf Swiss Timemaker Sihlbruggstrasse 117 · 6340 Baar · Phone (0)78 613 19 16 · www.schlumpf.swiss

Carefully remove the foam in the upwards direction.

Using the provided torx bit, remove the screws and wooden slats at the bottom.

Please find further instructions to install your Time Machine on the following pages.

Remove the two rubber bands from the top wheels, and the protective cover from the anchor wheel.

Carefully remove the pendulum assembly from the card-board sheet.

Attach the pendulum

Ensure the point in front is exactly positioned in the conical hole and the one at the back sits in the slot.

Installing the Time Machine TM3

Fabrical GmbH · Florian Schlumpf Swiss Timemaker Sihlbruggstrasse 107 · 6340 Baar · Phone +41 78 613 19 16 · sales@schlumpf.swiss · www.schlumpf.swiss

Watch the position of the anchor pallets

The anchor pallets should have the same engagement in each position. This may be regulated by adjusting the foot screws. Only adjust the anchor pallets if necessary!

Adjusting the foot

Adjust the foot so the pendulum hangs straight and the foot stands on the floor on all its screws.

The Time Machine is standing straight, when both pendu-lum rods are positioned in the same distance to the wind-ing spindle.

Wind the Time Machine

Insert the key in front underneath the hour wheel and wind the mainspring by turning it counterclockwise 15 times.

Key storage

Store the key in the mount on the left of the back side of the machine.

Connect the hands

The hands are magnetic and easy to mount, adjust and remove.

Fine-tuning

Your Time Machine was adjusted before delivery. You can easily readjust it by sliding the disk on the pendulum rods up or down.

Move disk up: clock runs faster

Move disk down: clock runs slower

Your Time Machine is ready!

Fabrical GmbH · Florian Schlumpf Swiss Timemaker Sihlbruggstrasse 117 · 6340 Baar · Phone (0)78 613 19 16 · www.schlumpf.swiss