ORIGINALSby Timesavers
Brush type ApplicationSuitable for
Aluminium Oxide
Silicon Carbide
Cross Flex
Cutting skin oxide
removal brush
Korfi l brush
Steel
Aluminium
Stainless steel
Especially for
aluminium
All metals
Steel with
blue oxide on
vertical faces
Aluminium
Slashed construction: 5 mm wide, all sorts
of materials, large radius until at least
2 mm (steel & aluminium (set of 8 brushes))
Part. no. 599316 599325 599317
Grit: 60 80 100
Slashed construction: 5 & 3 mm wide, more
suitable for edge rounding of small holes, finer
surface roughness (= lower RA worth) and less
stiff / less aggressive (set of 8 brushes)
Part. no. 599308 599306 599305 599326
Grit: 100 120 180 400
Longer brush life due to better chip removal
lesser smearing of the brush (set of 8 brushes).
Part. no. 599303
Grit: 180
For a “ No Way “ (directionless) finish and
removal of milling marks aluminium surfaces.
Standard grit size is 120 (set of 8 brushes).
Part. no. 599297
Grit: 120
Standard (not adjustable) brush for optimal oxide
skin removal on cut face.
Part. no. 459667 (set of 4 brushes) - 1 mm
Part. no. 460368 (set of 8 brushes) - 1 mm
Adjustable brush for use in combination
with deburring brushes.
Part. no. 460076 (set of 4 brushes) - 1,25 mm
For e.g. deep pockets and upstands
Part. no. 599329 (set of 8 brushes) - 1,25 mm
Grit: 120
1)
2)
3)
4)
5)
TIMESAVERS ORIGINALSOVERVIEW BRUSHES 42 RB SERIES
Order? Questions? Check: www.timesaversint.com Mail: [email protected] Tel: +31 - (0)113 238911
Slashed construction
Slashed construction
5 mm
5 mm
5 mm
3 mm
3 mm
5 mm
5 mm
5 mm