FIGURE 9

Stair PanelAttach clip

3” Sq. PostKit

ColonialTop Snap

Stair Panel

Bottom Snap

FIGURE 8

BOTTOM RAIL SNAP

TOP RAIL SNAP

34"TO38"

A

B

B

ADAHANDRAIL

ASSY 3" SQ.POST

TOP RAIL

REF. STAIR

DETAIL AMOUNT

HANDRAILCONNECTOR

3X FASTENER

SECTION B-BMOUNT

Stair Panel Actual Lengths: 6’ Panels = 69.43”; 8’ Panels = 91.31”

• Clamps

(williamsrailing.com)

UltraLox

3” x 3” post attached at each end and

STAIR INSTALLATIONINSTRUCTIONS

NOTE: IF INSTALLING POST LIGHTING, WIRING MUST BE INSTALLED PRIOR TO SECURING POSTS TO DECK/STAIR SURFACE AND INSTALLING TOP RAIL SNAPS.

©2019 WES, LLC. All Rights Reserved. Version 1.4

Installation Videos available at:

williamsrailing.com

6”

Temporary clamp panel against posts and mark for miter cuts

*Tip -Lay 2” x 4” board on nose of stair treads

Level post

FIGURE 1

34” to 38”from stair nosingto top of rail

FIGURE 7FIGURE 5

4x cut panel to suit

4x cut panel to suit

Temporary 2” x 4” spacer board

With #2 pencil place mark on post at top of lower stair extrusion

Stair railing panel

FIGURE 2

FIGURE 3

FIGURE 4

Install, TEK screws,2x #8 x 3/4” outside2x #8 x 3/4” inside

Rail clip

FIGURE 6

RAIL CLIP

2X INSTALL#8 X 3/4"TEK SCREWINSIDE

2X INSTALL#8 X 3/4"TEK SCREWOUTSIDE

PENCILMARK LINE

CLIPTOP EDGE

TemporarilyInstalled Post

,

Cut 1/16” less than opening size.

Temporarily clamp top and bottom rail snap againstposts and mark for miter cuts. Cut 1/16” less than opening size.

www.williamsrailing.com