Towards simulation of electric fields in silicon detectors using the Robin Hood method
Hrvoje Štefančić
Theoretical Physics Division Ruđer Bošković Institute
(based on joint work with Hrvoje Abraham and Predrag Lazić)
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
2
Electric field strength in a segment of a Si microstrip detector
• Peculiar behavior of the Si microstrip detector at the interstrip region observed by the IRB group (communicated by Soić and Grassi)
• The configuration of the electric field in the interstrip region might be relevant for the explanation
• Robin Hood as a method for the precise calculation of the field
• This workshop as a testing ground of the idea (with some preliminary results)
• Discuss and asses the potential of the method in Si detectors
• Learn about possible unpercieved opportunities or overlooked pitfalls
• In which direction to proceed
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
3
Outline of the presentation
• The description of the Robin Hood method – a novel tool• Properties of the RH method (capacity of a unit cube,
corrugated surfaces) – a powerful tool• Applications in particle detectors (micro-pattern) – a tool
relevant for the field of particle detectors• Preliminary results for silicon detectors – a discussion
point
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
4
The Robin Hood method• How do we calculate the electric field in some electrostatic
system with a complex geometry?– Solve the Poisson equation by the discretization of the 3D space - Finite
Difference Methods (FDM), Finite Element Methods (FEM)– Determine the sources at surfaces (surface charge distributions at
conductors, polarization of dielectrics) – Boundary Element Methods (BEM)
– The Robin Hood method falls into the class of Boundary Element Methods• Predrag Lazić, Hrvoje Štefančić, Hrvoje Abraham, J. Comp. Phys.
213 (2006) 117.• Predrag Lazić, Hrvoje Štefančić, Hrvoje Abraham, Engineering
Analysis with Boundary Elements, 32 (2008) 76.
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
5
The Robin Hood method – how does it work?
• Imagine and example of a point charge close to an insulated sphere– Divide the surface of the sphere into triangles (discretization)– Calculate the initial value of the electric potential at all triangles– Find the triangles with the maximal and the minimal value of the
potential – Transfer charge from the triangle with the maximal potential to the
triangle with the minimal potential so that after the transfer their potentials are equal (that is why the Robin Hood name – taking from the rich to give to the poor)
– Update the value of the potential at all triangles– Iterate the procedure (find max and min, charge transfer, update) until
the requirement on the precision is achieved
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
6
The result – a point charge close to an insulated sphere
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
7
The Robin Hood method
• The Robin Hood method is also applicable to – Conductors at a fixed potential– Dielectrics (the condition of equipotentiality is
replaced by the condition on fields on both sides of the interface between the dielectrics)
– Magnetostatics– Electromagnetism– Systems of linear equations– ...
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
8
The metallic plate at a fixed potential
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
9
Water in connected pits – the redistribution problem
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
10
Linear memory consumption• The required memory scales linearly with N (number of
triangles) – other BEM have a memory requirement ~ N2
• The record (2008) in the precision of the capacity of the unit cube: C=0.66067786 ±8 x 10-8 in units of 1/4 π ε0
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
11
Complex geometries• Corrugated plane (P.Lazić, B. N. J. Persson, Surface-roughness–
induced electric-field enhancement and triboluminescence, Europhys. Lett. 91 (2010) 46003)
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
12
The same convergence at many scales• Point charge close to the sphere kept at a fixed
potential
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
13
The Robin Hood method and the particle detectors and accelerators
• Micro-pattern detectors (Micromegas)• Katrin collaboration experimental setup• IEC fusor
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
14
Micro-pattern detectorsPredrag Lazić, Denis Dujmić, Joseph A. Formaggio, Hrvoje Abraham, Hrvoje Štefančić, New approach to 3D electrostatic calculations for micro-pattern detectors, JINST 6 (2011) P12003
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
15
Types of micro-mesh• Dependence of the electronic transparency on the type of
micro-mesh (rectangular, cylindrical, woven, calendered)
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
16
Electric field at the micro-mesh
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
17
Electric potential at the micro-mesh
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
18
Ez at the micro-mesh
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
19
Exy at the micro-mesh
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
20
Transparency vs. field
• Calculations using the electric-field tracking (EFT) method and micro-tracking (MT)
• The less symmetrical the electric field at the micro-mesh, the larger the electronic transparency
• Transparency in general higher for EFT than for MT• Transparency the best for cylindrical and calendered,
intermediate for woven and the worst for rectangular
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
21
Electronic transparency vs. optical transparency
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
22
Dielectric spacer
• Full cylinder or hollow (capillary), vertical or horizontal
No spacer Full spacer Hollow spacer
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
23
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
24
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
25
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
26
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
27
Detector system of the KATRIN experimental setup
J. A. Formaggio, P. Lazić, T. J. Corona, H. Štefančić, H. Abraham, and F. Gluck, Solving for Micro- and Macro-Scale Electrostatic Configurations Using theRobin Hood Algorithm, Progress In Electromagnetics Research B, 39 (2012) 1.
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
28
IEC fusor
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
29
Si microstrip detectors – from the viewpoint of electric field modeling
• Periodic structures with many details • Various dielectric layers (SiO2, Si with various dopants)• The geometry of dielectric layers is not precisely known
(especially for SiO2)• Particular elements have orders of magnitude different
dimensions (e.g. Al strips have length ~ cm, width ~ mm, thickness ~ mm) – potential problems with sharp-angled triangles
• The separation of strips (~ 50 mm) is much smaller than their width
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
30
Si microstrip detectors – modelling assumptions
• Entire system could be analyzed in full (this lies within the capabilities of the Robin Hood Solver), but it is more instructive to focus on the interstrip region– the most interesting configuration of the electric fields– Observed reversed polarity signals for particles passing the
interstrip region (Soić, Grassi)• Define an “elementary cell” – centered at the interstrip region• All layers of Si (differently doped) have the same dielectric
constant (Capan)• Al strips can be well described as conducting plates• Various geometries for the SiO2 layer
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
31
No SiO2 – total field strength
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
32
No SiO2 – field strength in the x direction
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
33
No SiO2 – field strength in the y direction
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
34
No SiO2 – field strength in the z direction
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
35
“Thick” SiO2 layer – start from the Si block
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
36
“Thick” SiO2 layer – add a Si cylinder
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
37
“Thick” SiO2 layer – make a Boolean difference of the Si plate and the cylinder
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
38
“Thick” SiO2 layer – add a SiO2 cylinder
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
39
“Thick” SiO2 layer – make a Boolean difference of the SiO2 cylinder and a cube
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
40
“Thick” SiO2 layer – add Al plates
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
41
What next?
• Realistic geometry of the SiO2 layer• Dependence on the thickness of the Si
(decoupling of top and bottom strips)• Spatial charge accumulated at SiO2
• Full system analysis (interference of adjacent strips)
• Simulation of charge transport (big step)
Silicon Detector Workshop, Split, Croatia, 8-10 October 2012
42
THANK YOU FOR YOUR ATTENTION