Date post: | 15-Mar-2016 |
Category: |
Documents |
Upload: | nathan-trevino |
View: | 35 times |
Download: | 0 times |
Fabrication GuideTriten Range Of Products
Cutting
Four Methods Of Cutting• Plasma Arc• Water Jet• Carbon Arc• Abrasive Saw
• NOT by oxy-gas
Plasma Arc Cutting• Recommended method.• Material can be cut with
hand-held model (inexpensive)
• Plates can be cut from either side
• Consider plasma arc taper
• High definition plasma for greater precision
• Angled torch for countersunk holes
Cold Forming
Material can be pressed or rolled with care
Cold Forming• Rolling always in the
same direction as the overlay beads.
• Convex recommended• Concave with great
care
• Pressing always with a radiused tool, never with a “knife”
Fixing Holes
Methods of attachment• Material cannot be
mechanically drilled or countersunk using traditional methods
• Either :– Plug welding– Stud Welding– Countersunk bolts– Pre-machined inserts
Fixing Holes• Direct plasma arc
piercing gives a perfectly acceptable hole quality for most applications
• A machined insert can be welded in place but is often a more expensive method
For further information, refer to the Triten Fabrication Guide