Is your gas dryer not heating properly?

There may be various reasons for the problem…….But the most common sources of the problem of dead dryer comes from several areas:

• Igniter and Thermal Fuse• Thermostat and Radiant flame sensor• Power Issues• Heating coils for gas valve• Overloading• Wrong Settings

Cause #1 :: A Broken Igniter or a Broken Timer

Most primary cost for a dryer not heating is a broken igniter. If the igniter does not work properly, it will Not ignite the heater and the dryer unit will not dry your cloths.

Check for blown fuses, as well as other broken elements, as these could also be contributing tothe problem. A broken timer could also cause the heater and the blower to stay inactive.

Cause #2 :: Defective Thermostat and Sensors

Another reason may be a defective thermostat. When The thermostat is not fitted under the linttrap or it is not attached to the blower housing,the dryer may not dry. In this case, you need to replace the broken thermostat.

The sensor could also experience the same problem.Sensors are like silver discs and they are located underthe drum. If they stop working, then the entire unit will fail to dry cloths.

Cause #3 :: Failed power Connection

Check if the dryer is properly plugged in and then check the wires and connections. it needs around 110 volts in a gas dryer to heat-dry cloths

Sometimes the dryer mail fail to power up due to overheating during previous use. The power cords may burn out for this reason and the dryer require a repairing service to correct the problem.

Cause #4 :: Defective Gas Valve Coils

If there is a defect on the gas valve coils the dryerWill not heat. If the vent is Clogged, then it preventairflow and will raise the temperature higher thanwhat is set.

Gas valve coils, which normally let the valve openand allow the gas to pass through, may need to be replaced or perhaps you just need to give the valves and the vents a thorough cleaning.

Cause #5 :: Dryer Overloading and choosing wrong drying option

Avoid filling the dryer with excess clothes and makesure that the air can flow freely inside the drum. Overloading a dryer will prevent the dryer from drying the load completely

You should choose proper drying setting forProper result. Choosing the ‘DRY’ option will Leave the unit On for long time. Choose the‘NORMAL’ option for delicate fabrics.

To troubleshoot the problem you need to checkfor any blown or broken parts. Telltale signs include smoky odors or a charred appearance in some dryer areas.

You will need to open the dryer up in order tosee what is inside. Then replace the affected partWith Do-it-yourself appliances repairing parts fromPandora’s OEM (www.pandorasoem.com) . You can also email us your model number and/or question and get an answer the same day!

…………… Some of our top selling products are ………….

Dryer Blower Wheel Dryer Control Board Dryer Heater Relay

Dryer Knob Dryer Temp Thermostat Dryer Thermostat

Our Store address :: Pandora's OEM Appliance Parts PO Box 330919 Murfreesboro, TN 37133

Website Address :: www.pandorasoem.com

Fax ::

1-(615)-890-0107

All parts sold on Pandorasoem.com offerYou (the Customer) a free domestic shipping option.