8/14/2019 Tutorial CDMA 1x PAT for SmartFren Project_ver.1_19Dec2011.pdf

1/15

All rights reserved. No part of the documentation may be reproduced, transmitted, transcribed, or translated into

any language, in any form or by any means, without prior written permission of ZTE Corporation.

TUTORIAL OF RF

PROVISIONAL ACCEPTANCE TEST (PAT) PROCEDURES

FOR SMARTFREN TELECOM CDMA 1x NETWORK

by

Munawar Khalil

8/14/2019 Tutorial CDMA 1x PAT for SmartFren Project_ver.1_19Dec2011.pdf

2/15

Tutorial of RF CDMA 1x PAT Procedure

All rights reserved. No part of the documentation may be reproduced, transmitted, transcribed, or translated into

any language, in any form or by any means, without prior written permission of ZTE Corporation.

Table of Contents

TUTORIAL OF RF ................................................................................................................................ I

TABLE OF CONTENTS ....................................................................................................................... 2

1 GENERAL INFORMATION ........................................................................................................ 41.1 Purpose ............................................................................................................................................... 41.2 Test Method ......................................................................................................................................... 4

2 DRIVE TEST 1X PAT PROCEDURES ...................................................................................... 52.1 Call Setup Success Rate (CSSR Voice) .................................................................................................... 52.2 Call Drop Rate (CDR Voice) ................................................................................................................... 52.3 Call Setup Time Origination ................................................................................................................. 5

2.4

Call Setup Time Termination ................................................................................................................ 6

2.5 Soft Handoff Success Rate (SHOSR) ...................................................................................................... 62.6 Forward Frame Erasure Rate (FFER) ..................................................................................................... 72.7 Reverse Frame Erasure Rate (RFER) ...................................................................................................... 72.8 Call Drop Rate 1x Packet (CDR 1x Data) ................................................................................................ 72.9 Hard Handoff Success Rate (HHOSR) .................................................................................................... 83 PAT REPORT ................................................................................................................................ 93.1 Call Setup Success Rate (CSSR Voice) .................................................................................................... 93.2 Call Drop Rate (CDR Voice) ................................................................................................................... 93.3 Call Setup Time Origination ................................................................................................................103.4 Call Setup T ime Termination ...............................................................................................................10

8/14/2019 Tutorial CDMA 1x PAT for SmartFren Project_ver.1_19Dec2011.pdf

3/15

Tutorial of RF CDMA 1x PAT Procedure

All rights reserved. No part of the documentation may be reproduced, transmitted, transcribed, or translated into

any language, in any form or by any means, without prior written permission of ZTE Corporation.

3.5 Soft Handoff Success Rate (SHOSR) .....................................................................................................113.6 Forward Frame Erasure Rate (FFER) ....................................................................................................12

3.7

Reverse Frame Erasure Rate (RFER) .....................................................................................................12

3.8 Call Drop Rate 1x Packet (CDR 1x Data) ...............................................................................................133.9 Hard Handoff Success Rate (HHOSR) ...................................................................................................13

4 APPENDIX ................................................................................................................................. 144.1 Provisional Acceptance Test Items Summary .......................................................................................144.2 Logging File Name...............................................................................................................................15

8/14/2019 Tutorial CDMA 1x PAT for SmartFren Project_ver.1_19Dec2011.pdf

4/15

Tutorial of RF CDMA 1x PAT Procedure

All rights reserved. No part of the documentation may be reproduced, transmitted, transcribed, or translated into

any language, in any form or by any means, without prior written permission of ZTE Corporation.

1 General Information

For optimization and PAT use CNT1-C 5.94 for test and CNA1-C 7.2 for analysis.

1.1 Purpose

This document is intended as an RF Acceptance test for SmartFren Telecom CDMA 1x network. It

is developed based on PT. SmartFren Telecom requirements and ZTE - SmartFren agreements.

1.2Test Method

1) 1X Drive Test (Voice) Setup:

GPS

Handset

Handset

Handset

2) 1X Drive Test (Data) Setup:

GPS

Modem

3) During Drive testing 70% loading will be done using OCNS to achieve the required loading as perExhibit D.1

8/14/2019 Tutorial CDMA 1x PAT for SmartFren Project_ver.1_19Dec2011.pdf

5/15

Tutorial of RF CDMA 1x PAT Procedure

All rights reserved. No part of the documentation may be reproduced, transmitted, transcribed, or translated into

any language, in any form or by any means, without prior written permission of ZTE Corporation.

2 Drive Test 1x PAT Procedures

2.1 Call Setup Success Rate (CSSR Voice)

a) Start the ZXPOS test software CNT1 and ensure that the program is communicating with thephone.

b) Setup the ZXPOS test software CNT1 as Periodic EVRC Call Origination with the following

parameters:

o Choose EVRCas the Service option, and Originationas the call patterno Select Call Count in Plan Setting tab: 999999o Call Time: 40 seconds.o Idle Timer: 10 seconds.o Call Setup Timer: 15 seconds.

c) Start logging.

d) Start the call in call monitor.

e) When the call-monitor program finishes DT route, stop logging.

2.2 Call Drop Rate (CDR Voice)

Just use 3.1 Call Setup Success Rate (CSSR Voice) log file to make this KPI, so no need to test this

item.

2.3 Call Setup Time Origination

Just use 3.1 Call Setup Success Rate (CSSR Voice) log file to make this KPI, so no need to test this

item.

8/14/2019 Tutorial CDMA 1x PAT for SmartFren Project_ver.1_19Dec2011.pdf

6/15

Tutorial of RF CDMA 1x PAT Procedure

All rights reserved. No part of the documentation may be reproduced, transmitted, transcribed, or translated into

any language, in any form or by any means, without prior written permission of ZTE Corporation.

2.4 Call Setup Time Termination

a) Start the ZXPOS test software CNT1 and ensure that the program is communicating with the

phone.

b) Set up the ZXPOS test software CNT1 as Periodic EVRC Call Terminationwith the followingparameters:

o Choose EVRCas the Service option, and Terminationas the call patterno Select Call Count in Plan Setting tab: 999999o Call Time: 40 seconds.o Tear Down Time: 10 seconds

c) Start logging.

d) Start the call in call monitor.

e) When the call-monitor program finishes DT route, stop logging.

2.5 Soft Handoff Success Rate (SHOSR)

a) Start the ZXPOS test software CNT1 and ensure that the program is communicating with the

phone.

b) Set up the ZXPOS test software CNT1as Continuous EVRC Callwith the following parameters:

o Choose EVRCas the Service option, and Terminationas the call patterno Select Redial If Dropand Continuous Callin Plan Setting tab,o Idle Timer: 10 seconds.o Call Setup Timer: 15 seconds.

8/14/2019 Tutorial CDMA 1x PAT for SmartFren Project_ver.1_19Dec2011.pdf

7/15

Tutorial of RF CDMA 1x PAT Procedure

All rights reserved. No part of the documentation may be reproduced, transmitted, transcribed, or translated into

any language, in any form or by any means, without prior written permission of ZTE Corporation.

c) Start logging.

d) Start the call in call monitor.

e) When the call-monitor program finishes DT route, stop logging.

2.6 Forward Frame Erasure Rate (FFER)

Just use 3.5 Soft Handoff Success Rate (SHOSR)log file to make this KPI, so no need to test this

item use.

2.7 Reverse Frame Erasure Rate (RFER)

The RFER is taking from the Continuous EVRC Call test both for 800MHz and 1900MHz, the IMSInumber test should be input in the OMC. Detail setting for this test can be seen in the following attachment.

Steps tosetting(record) the R

2.8 Call Drop Rate 1x Packet (CDR 1x Data)

a) Start the ZXPOS test software CNT1 and ensure that the program is communicating with thephone.

b) Set up the ZXPOS test software CNT1as 1xPeriodic Data Callwith the following parameters:

o Duration: 60 seconds.o Idle time: 10 seconds

8/14/2019 Tutorial CDMA 1x PAT for SmartFren Project_ver.1_19Dec2011.pdf

8/15

Tutorial of RF CDMA 1x PAT Procedure

All rights reserved. No part of the documentation may be reproduced, transmitted, transcribed, or translated into

any language, in any form or by any means, without prior written permission of ZTE Corporation.

c) Start logging.

d) Start the call in call monitor.

e) When the call-monitor program finishes DT route, stop logging.

2.9 Hard Handoff Success Rate (HHOSR)

Just use 3.5 Soft Handoff Success Rate (SHOSR)log file to make this KPI, so no need to test this

item.

8/14/2019 Tutorial CDMA 1x PAT for SmartFren Project_ver.1_19Dec2011.pdf

9/15

Tutorial of RF CDMA 1x PAT Procedure

All rights reserved. No part of the documentation may be reproduced, transmitted, transcribed, or translated into

any language, in any form or by any means, without prior written permission of ZTE Corporation.

3 PAT REPORT

3.1 Call Setup Success Rate (CSSR Voice)

a) Use Periodic EVRC Call Origination log file to check this KPI result.b) Open with CNA1-C 7.2 get data from Analysis menu, and then choose 1x Call Analysis

3.2 Call Drop Rate (CDR Voice)

a) Use Periodic EVRC Call Origination log file to check this KPI result.

b) Open with CNA1-C 7.2 get data from Analysis menu, and then choose 1x Call Analysis.

8/14/2019 Tutorial CDMA 1x PAT for SmartFren Project_ver.1_19Dec2011.pdf

10/15

Tutorial of RF CDMA 1x PAT Procedure

All rights reserved. No part of the documentation may be reproduced, transmitted, transcribed, or translated into

any language, in any form or by any means, without prior written permission of ZTE Corporation.

3.3 Call Setup Time Origination

a) Just use Periodic EVRC Call Origination log file to check this KPI result.b) Open with CNA1-C 7.2 get data from Analysis menu, and then choose 1x Delay

Analysis.

3.4 Call Setup Time Termination

a) UsePeriodic EVRC Call Termination log file to check this KPI result.

8/14/2019 Tutorial CDMA 1x PAT for SmartFren Project_ver.1_19Dec2011.pdf

11/15

Tutorial of RF CDMA 1x PAT Procedure

All rights reserved. No part of the documentation may be reproduced, transmitted, transcribed, or translated into

any language, in any form or by any means, without prior written permission of ZTE Corporation.

b) Open the CNA1-C 7.2 and get data from Analysis menu, and then choose 1x Delay

Analysis.

3.5 Soft Handoff Success Rate (SHOSR)

a) Use Continuous EVRC Call log file to check this KPI result.

b) Open with CNA1-C 7.2 get data from Analysis Menu, and then choose 1x Handoff Event

Analysis.

c) To calculate this KPI, use the Soft Handoff Success Rate (SHOSR) = Number of soft

handoff successful /Total number of soft handoff.

8/14/2019 Tutorial CDMA 1x PAT for SmartFren Project_ver.1_19Dec2011.pdf

12/15

Tutorial of RF CDMA 1x PAT Procedure

All rights reserved. No part of the documentation may be reproduced, transmitted, transcribed, or translated into

any language, in any form or by any means, without prior written permission of ZTE Corporation.

SHOSR = OK Number HO (1Way HO + 2Soft HO + 2Softer HO + 3Soft HO + 3Softer HO +

3Soft/Softer HO + 4Way HO + 5Way HO + 6Way HO) / Total Number HO (1Way HO +

2Soft HO + 2Softer HO + 3Soft HO + 3Softer HO + 3Soft/Softer HO + 4Way HO + 5Way

HO + 6Way HO)

3.6 Forward Frame Erasure Rate (FFER)

a) Use Continuous EVRC Call log file to check this KPI result.

b) Open with CNA1-C 7.2 get data from Analysis Menu, and then choose Data Statistic.

c) Export the F-FCH FER result to Excel.

d) Calculate the Average value; The Achievement KPI for FFER < 2%.

3.7 Reverse Frame Erasure Rate (RFER)

a) Use the OMC data export from cdma-bss3g-systemtool-ntp;

8/14/2019 Tutorial CDMA 1x PAT for SmartFren Project_ver.1_19Dec2011.pdf

13/15

Tutorial of RF CDMA 1x PAT Procedure

All rights reserved. No part of the documentation may be reproduced, transmitted, transcribed, or translated into

any language, in any form or by any means, without prior written permission of ZTE Corporation.

b) Calculate the Average Value; the achievement KPI for RFER < 2%.

3.8 Call Drop Rate 1x Packet (CDR 1x Data)

a) Use 1xPeriodic Data call log file to check this KPI result.

b) Open with CNA1-C 7.2 get data from Analysis Menu, and then choose 1x Handoff Event

Analysis.

3.9 Hard Handoff Success Rate (HHOSR)

a) Use Continuous EVRC Call log file to check this KPI result.

b) Open with CNA1-C 7.2 get data from Analysis Menu, and then choose 1x Handoff Event

Analysis.

c) To calculate this KPI, use the Hard Handoff Success Rate (HHOSR) = Number of Hard

handoff successful /Total number of Hard handoff.

8/14/2019 Tutorial CDMA 1x PAT for SmartFren Project_ver.1_19Dec2011.pdf

14/15

8/14/2019 Tutorial CDMA 1x PAT for SmartFren Project_ver.1_19Dec2011.pdf

15/15

Tutorial of RF CDMA 1x PAT Procedure

All rights reserved. No part of the documentation may be reproduced, transmitted, transcribed, or translated into

1 Cell_CDR_Performance98% Cells

CDR =1%

98% Cells

CSSR >=1%OMC

3 Cell_AFR_Performance