U Fold Tutorial
• Trim cardstock to 4.25 x 7.5
• Score at 1.5”, 2.5”, 5” and 6”
• Cardstock: 1 X 3.5 scored at 0.5 and 3 Note: this piece is optional, to be used for additional elements, ie my tree stump with Fox
• To make the fence, stamp cardstock with Hardwood Stamp
• Cardstock: 1 X 5.5 (I cut mine .5” 5.5”) X 2 because its a fence)
• Cut 5 strips from Hardwood stmped CS @ .25” x 2” Snip one end to a point
• Fold and crease score lines of Card Base
• This is the optional piece. Fold to a Z
• Add tear and tape or wet glue to each end as shown
• Line up your strip with left fold and adhere Notice left placement
• So far your base should look like this
• Now adhere to other half if card base as shown
• Your base can now either lie flat to the left or right
• Overhead view
• Next is the “fence” Adhere Tear and tape to only the far ends of the base. Attach your two “planks”
• With the left side open and laying flat adhere to opposite side
• You should now be able to lie flat favoring either the left OR the right of your card
• Overhead view
• Add upright “slats” using dimentionals as shown, 2 on left panel two on right panel and one in the center
• Decorate as desired