4
U13 TECHNICAL DATA SHEET on Dec 05 th 2018. CMC reserves the right to make changes at any time, without notice. TURBO diesel engine: -power 74 HP -liquid cooling Hydraulic drive with: - 2 motors and gear units with drum brakes integrated on rear wheels - control for forward, reverse and neutral gear - variable-flow pump Double speed to be selected by electric switch: working speed 0-13 Km/h; transferring speed 0-26 Km/h Steering on front wheels Closable platform for cones Telescopic pointer with pneumatic lift Steering-wheel with adjustable inclination, mounted on sliding support for following driver position Seats and console unit sliding (left/right) up to above marking unit Sunshade roof Glass bead system consisting of: -pressurized glass bead tank: 1 tank capacity 280 l (max pressure 0,5 bar) or 3 tanks capacity 100 l (max pressure 6 bar). With regulator of pressure and moisture separator -automatic glass bead gun with air of distribution. Diffuser with adjustable slope and adjustable opening angles -closing delay regulator for bead gun Screw compressor: -flow air rate 1987 l/min Electronic spacing device C8000: - 8 programs storable - control: upto 3 guns with only one program - alarm when speed is outside the range of minimum/maximum speed set - data recorded for each gun: total solid line metres - total data recorded for machine: total driven Km. For airless configuration, instead of C8000 is possible equipped machine with: Electronic controller and spacing device C9000: - 10 programs storable - control: upto 3 guns with 3 different programs simultensously; glass bead delay for each gun; up to 2 airless pumps with possibility to compare pressures and ratio (e.g. ratio 50:50 or 98:2) - display of effective applied thickness (avergae every 250 m), with alarm when the speed of application is not compatible with thickness set - alarm setting for: delta pressure between 2 pumps, zero pressure, pump not working - data recorded for each gun: applied thickness in micron; total working hours; total driven metres; total solid line metres; total empty space metres; total sprayed paint - data recorded for each pump: total number of pump cycles - total data recorded for machine: total working hours, total driven metres; total driven Km; total sprayed paint; total hours and pump cycles - daily report, downloadable with USB stick. Storable capacity 7 days. Thickness applied each minute (with date and time) Photo doesn’t show standard machine. STANDARD FOR ALL CONFIGURATIONS Machine is equipped with all safety devices according to EU requirements. Machine conforms to: EU Directive 2006/42/EC on Machinery EU Directive 14/68/EU for Pressure Equipment (PED directive) U13 TECHNICAL DATA SHEET Dimensions: 460x128x h 220 cm
