Barmac (A Division of Amgrow Pty Ltd) 82 Christensen Road,
Stapylton Qld 4207 | P.O. Box 698, Beenleigh Qld 4207 | Ph: (07)
3802 5050 | Fax: (07) 3807 6369 | www.barmac.com.au
UMBRELLA - Non-Ionic Sticker Spreader Spray Adjuvant
Barmac (A Division of Amgrow Pty Ltd) 82 Christensen Road,
Stapylton Qld 4207 | P.O. Box 698, Beenleigh Qld 4207 | Ph: (07)
3802 5050 | Fax: (07) 3807 6369 | www.barmac.com.au
UMBRELLAActive Constituent: 905 g/L di-1-p-MENTHENE
Umbrella
Umbrella from Barmac is a multi-purpose spray adjuvant designed
to increase the efficiency of applied pesticides and fertilisers in
agricultural and horticultural situations. Umbrella forms a rain
fast film over the applied pesticide solution, securing it into the
leaf, reducing environmental losses and enhancing application
efficacy through reduced drift. Umbrella also optimises spreading
and surface coverage on hard to wet plant surfaces, further
improving application results.
Umbrella Benefits
• Premium multi-purpose adjuvant for use in a broad range of
situations• Reduces off target drift, improving environmental
safety• Improves rain fastness of contact protectant chemistries•
Increases penetration efficacy of systemic chemistries into the
plant• Enhances spreading on hard to wet plant surfaces• Soft on
the plant’s cuticle – excellent plant safety
Pack Sizes
Available in 5 & 20 L packs
Colour pH SGAmber Neutral 0.94
PRODUCT CHARACTERISTICS
Barmac (A Division of Amgrow Pty Ltd) 82 Christensen Road,
Stapylton Qld 4207 | P.O. Box 698, Beenleigh Qld 4207 | Ph: (07)
3802 5050 | Fax: (07) 3807 6369 | www.barmac.com.au
Barmac (A Division of Amgrow Pty Ltd) 82 Christensen Road,
Stapylton Qld 4207 | P.O. Box 698, Beenleigh Qld 4207 | Ph: (07)
3802 5050 | Fax: (07) 3807 6369 | www.barmac.com.au
UMBRELLA - Non-Ionic Sticker Spreader Spray Adjuvant
DIRECTIONS FOR USE (Refer to product label for more detailed
instructions)
APPLICATION
Umbrella is a sticking-spreader agent designed to control the
life of pesticides. It is compatible in the spray tank with
pesticides and fertilisers. Under most conditions, apply sprays
containing Umbrella with at least one hour of daylight, before
anticipated rain. Sunlight is needed for the protective film to
set. Umbrella has the ability to allow secondary applications to
penetrate.
Add Umbrella to the spray tank as the last ingredient. Rinse
tank, lines and nozzles, immediately after spraying, with water.
After rinsing, there may still be a small amount of sticky residue
in the tank. This will help to prevent rusting and corrosion. It
will not clog nozzles when sprayer is next used. If spray happens
to hit non-target surfaces, it can be removed with soap and water.
On drying or with premium grade or white kerosene after the film
has dried or set.
NOTE:
The suggested rates of application are designed for typical use
conditions and should be used as a guide only. Do not foliar apply
during the heat of the day (> 25 DegC) when evaporation rates
are at their highest. It is recommended that when foliar applying
to a crop or area for the first time, or in combination with other
chemicals, a small test area should be sprayed and observed for
phytotoxicity prior to the total spray. Foliar spraying is
recommended during early morning or late afternoon. Use the minimum
foliar application rate on young or sensitive crops. Applying
additional products in the same tank mix increases the phytotoxic
risk to crops. Because climatic and soil conditions, application
methods, irrigation and agricultural practices are beyond the
control of Barmac and cannot be foreseen, Barmac accepts no
responsibility whatsoever for any commercial damage, loss or other
result following the use of this product whether used in accordance
with directions or not, subject to any overriding statutory
provision and provided that such liability under those provisions
shall be limited to the replacement of the goods as supplied or the
rendering again of the services that are provided. The buyer
accepts and uses this product subject to these conditions.
