User Guide for Octopus Wi-Fi Printing Service
Please follow the steps below to install the printer driver and configure your own
notebook:
1. Download the Wi-Fi printing driver
2. Double click the driver (exe file) and click “Yes” button
3. Select the corresponding Windows OS (32-bit or 64-bit)
4. If not sure, go to Windows’ Control Panel > System
5. Locate the “System Type” (e.g. 32-bit Operating System)
6. It will create the folder for the printer driver under C: temp/CUHK
7. (optional) Some users reported that the following box prompt out during the
installation.
If this happen, please run the following command at the DOS prompt.
cscript //h:cscript //s
For Windows 8 / 10 users, you may need to follow the procedure below to type
in the command:
Search cmd from the Apps screen
Right click the Command Prompt and select “Run as Administrator”
Windows 8 Windows 10
Select Yes from the prompt
Enter the following command at the Command Prompt:
cscript //h:cscript //s
8. Connect to CUHK Wi-Fi (SSID: CUHK, CUHKa, CUguest, eduroam, Universities
WiFi) and select the corresponding “Wi-Fi Printing / Copier” driver for your
location
9. You may check the Printing Preferences if needed and click “OK”
10. Enter a “User ID” and “Password” that you like and click “OK”
Notes:
Both User ID and Password can be set by the user.
User ID can only made of a maximum of 8 alphanumeric characters (a-z, A-Z, 0-9).
Password can only be made of 4-8 digit numbers (0-9).