USER    MANUAL  

WARNING

Read all warnings and instructions before assembling this inflatable device and keep

instructions for future use.

AGES 3 to 14 years

 

WARNING Read all warnings and instructions before assembling this inflatable device and keep instructions for future use. Failure to follow the installation and operating instructions presents a risk of serious injury or death.

• FOR INDOOR HOUSEHOLD USE ONLY on a flat and level floor surface.

• Adult supervision is required at all times. Adult supervision should be either from inside the AirFort or outside at the viewing window.

• Age range of users: 3 to 14 years • Maximum number of users: 3 to 5 • DO NOT use this product or locate the fan

or power cord near water, open flames, potential falling objects or in indoor areas where vehicles frequent, such as garages.

• DO NOT place or throw objects of any kind on this product at any time.

• DO NOT run in or around this product. • DO NOT inflate or use within 4 feet of any

objects. • DO NOT jump on this product.

1

 

• Keep the bottom edge all around the AirFort free from obstruction at all times.

• DO NOT allow rough play such as running or somersaults.

• DO NOT attach any items to this product, such as, but not limited to, jump ropes, clotheslines, pet leashes, cables or chains, as they have the potential to cause strangulation.

• DO NOT consume food or drink inside this product.

• DO NOT allow users to wear clothing with hard, sharp, or dangerous components.

• DO NOT allow users to play with sharp objects in or around this product.

• DO NOT allow pets in or on the AirFort. • In case of a power outage or sudden

deflation of the AirFort, exit the AirFort. DO NOT use until AirFort is re-inflated.

• If AirFort becomes torn or damaged, discontinue use of the product and contact us.

• Use ONLY a GFCI protected electrical outlet to plug the fan electrical cord into.

2

 

• Use ONLY a 20” household box fan or 18” tabletop round fan that is certified by a recognized electrical testing laboratory, is child resistant and stable, and has an electrical cord that is protected.

• ALWAYS secure this product to the fan per the instructions.

• DO NOT use a gasoline powered fan or blower to inflate this product.

• DO NOT use an extension cord with the fan.

• DO NOT allow any part of the electrical cord to be inside the inflated product.

• DO NOT allow foreign matter to be blown into the air tunnel.

• DO NOT allow children near the fan. NOTE: Remove all packaging materials prior to use. DO NOT allow children to play with packaging. The storage bag is NOT a toy. DO NOT allow children to play with it.

3

 

Parts list 1- AirFort inflatable 4- 1” looped adhesive squares with backing 1- Drawstring storage bag 1- Instruction manual

Assembly and inflation instructions

1.Completely open and lay out the AirFort  as shown in Figure 1, with warning label facing up, in the location where it will be used, observing all the warnings above regarding this location.

Figure 1

4

 

2.Stretch out the fan shroud and read the warnings on the fan shroud. 3.Make sure the fan is NOT plugged into an electrical outlet. 4.Locate the four 1” looped squares with adhesive backing as shown in Figure 2.

Figure 2 Refer to the applicable instructions in the following pages for the type of fan used for inflation.

5

 

For assembly using a 20-inch Box Fan 1.Remove backing from the adhesive on each looped square and place them on the four corners of the fan as shown in Figures 3a and 3b.

Figure 3a Figure 3b 2.Attach the two white straps to the two looped squares on the top corners of the fan as shown in Figure 4.

Figure 4

6

 

3.Attach the two black straps to the two looped squares on the bottom corners of the fan as shown in Figure 5.

Figure 5 For assembly using an 18-inch tabletop Round

Fan 1.Remove backing from the adhesive on each looped square and place them on both sides of the fan in the locations shown in Figures 6a and 6b.

Figure 6a Figure 6b

7

 

2.Attach the two white straps to the two looped squares on the sides of the fan motor housing as shown in Figures 7a and 7b.

Figure 7a Figure 7b 3.Attach the two black straps to the looped squares on the sides of the fan base as shown in Figure 8.

  Figure 8

8

 

Inflation 1.Plug fan into an electrical outlet. 2. Turn the fan on to any setting to inflate. Your AirFort will inflate faster on the highest setting. 3.Fan must remain on for your AirFort to stay inflated. 4.Inflation may take up to 30 seconds depending on the type of fan and the speed setting. 5.Once inflated, you may be able to lower the fan speed setting to maintain inflation. 6.To enter and exit your AirFort, lift bottom edge anywhere around the product. The AirFort will temporarily deflate, but will re- inflate once the edge is returned to the floor as shown in Figure 9.

Figure 9

9

 

Deflation and disassembly When finished using your AirFort have all occupants exit the fort. ONLY THEN turn off the fan and unplug it from the electrical outlet. Remove the four straps from the fan and store your AirFort  in the provided drawstring storage bag. Maintenance and Care Proper maintenance of the AirFort will ensure the safety of the users as well as longevity of the product. When not in use, store the AirFort in the provided drawstring storage bag and keep in a cool, dry place. To clean: wipe with warm water and a soft cloth. If use of soap is needed, use a non-flammable, non-toxic cleaning and sanitizing solution such as Simple Green All-Purpose Industrial Cleaner ®.

10

 

“The toy kids use to play with all of their other toys!"

airfort.com