+ All Categories
Home > Documents > USER OPERATING INSTRUCTIONS - Cisco-Eagle, Inc. · • Enter 4 digit PIN > close locker which will...

USER OPERATING INSTRUCTIONS - Cisco-Eagle, Inc. · • Enter 4 digit PIN > close locker which will...

Date post: 22-Aug-2020
Category:
Upload: others
View: 0 times
Download: 0 times
Share this document with a friend
1
#User PIN New User PIN New User PIN EXAMPLE: #2244 6688 6688 Note: The Hallowell Electronic Combination Lock has a 10 button keypad and a # button. The # button is hidden beneath the handle when in the locked position. The lock requires a 4 digit PIN to operate. The lock has two operating modes: This lock is currently set to work in the following modes (see check box below). PERMANENT USE MODE (Locker assigned to single user) Note: In this mode the selected PIN will repeatedly open the lock. Lock will automatically relock. THE USER PIN FOR THIS LOCK IS DAY USE MODE (Shared use) Note: In this mode, the 4 digit randomly selected PIN will open the lock once and then be erased. PROCEDURE AS FOLLOWS: Enter 4 digit PIN > close locker which will now be locked. Enter same 4 digit PIN > lock will open and PIN will be erased. Note: When locked in this mode the RED LED will flash every 5 seconds to indicate locker/cabinet is locked. PENALTY TIME Entering three incorrect codes will cause the lock to shutdown for 10 seconds. TO CHANGE THE USER PIN: RESULT: User PIN is now 6688 PIN REJECTED PIN ACCEPTED Low Battery When the battery power is low the Red LED will flash 3 times before the Blue LED flashes to signal acceptance of the PIN. Batteries should be changed as soon as this happens. The lock will operate for 100 times with low battery. Fit new batteries by removing the upper fixing bolt and swinging the lock down. Refit the lock. X ELECTRONIC COMBINATION LOCK USER OPERATING INSTRUCTIONS 866-566-0500 www.Hallowell-List.com
Transcript
Page 1: USER OPERATING INSTRUCTIONS - Cisco-Eagle, Inc. · • Enter 4 digit PIN > close locker which will now be locked. • Enter same 4 digit PIN > lock will open and PIN will be erased.

#User PIN New User PIN New User PIN EXAMPLE: #2244 6688 6688

Note: The Hallowell Electronic Combination Lock has a 10 button keypad and a # button. The # button is hidden beneath the handle when in the locked position. The lock requires a 4 digit PIN to operate.

The lock has two operating modes:This lock is currently set to work in the following modes (see check box below).

PERMANENT USE MODE (Locker assigned to single user)

Note: In this mode the selected PIN will repeatedly open the lock. Lock will automatically relock.

THE USER PIN FOR THIS LOCK IS

DAY USE MODE (Shared use)

Note: In this mode, the 4 digit randomly selected PIN will open the lock once and then be erased.

PROCEDURE AS FOLLOWS:

• Enter 4 digit PIN > close locker which will now be locked.• Enter same 4 digit PIN > lock will open and PIN will be erased.

Note: When locked in this mode the RED LED

will flash every 5 seconds to indicate locker/cabinet is locked.

PENALTY TIME• Entering three incorrect codes will cause the lock to shutdown for 10 seconds.

TO CHANGE THE USER PIN:

RESULT: User PIN is now 6688

PIN REJECTEDPIN ACCEPTEDLow Battery When the battery power is low the Red LED will flash 3 times before the Blue LED flashes to signal acceptance of the PIN.

Batteries should be changed as soon as this happens. The lock will operate for 100 times with low battery.

Fit new batteries by removing the upper fixing bolt and swinging the lock down. Refit the lock.

X

ELECTRONIC COMBINATION LOCK

USER OPERATING INSTRUCTIONS

ELECTRONIC COMBINATION LOCK

866-566-0500 www.Hallowell-List.com

Recommended