+ All Categories
Home > Documents > VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum...

VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum...

Date post: 23-Aug-2021
Category:
Upload: others
View: 0 times
Download: 0 times
Share this document with a friend
16
VATM05B1
Transcript
Page 1: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

VATM05B1

Page 2: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

INTRODUCTION

IMPORTANT SAFETY INSTRUCTION ............................................................................

ELECTRICAL REQUIREMENTS ....................................................................................

PACKING LIST .............................................................................................................

INSTALLATION&ASSEMBLY INSTRUCTIONS ................................................................

USING YOUR AIR CONDITIONER ..................................................................................

CARE AND CLEANING ................................................................................................ .

TROUBLESHOOTING ...................................................................................................

1

3

4

5

10

11

12

Page 3: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

1

Page 4: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

2

INTRODUCTION TO REFRIGERANTS R32

9K

12K

18K

24K

The refrigerants used for air conditioners are environmentally friendly hydrocarbons R32. This kind of erant is combustible and odorless. Moreover, it can burn and explode under certain condition. However, there will be no risk of burning and explosion if you comply with the following table to install your air conditioner in a room with an appropriate area and use it correctly. Compared with ordinary refrigerants, Refrigerant R32 is environmentally friendly and do not destroy the ozone sphere and that its value of greenhouse effect is also very low.

Room area requests for air conditioner with Refrigerant R32

WarningsPlease read the manual before installation, using, maintenance.

Do not use means to accelerate the defrosting process or to clean, other than those recommended by the manufacturer.

Do not pierce or burn the appliance.

The appliance shall be stored in a room without continuously operating sources (for example: open flames, an operating ignition gas appliance or an operating electric heater.)

Please contact the nearest after-sale service center when maintenance is necessary. At the time of maintenance, the maintenance personnel must strictly comply with the Operation Manual provided by the corresponding manufacturer and any non-professional is prohibited to maintain the air conditioner.

The handling, installation, storage, servicing and disposal must comply with the provisions of gas-related national laws and regulations, and also national wiring regulation.

It is necessary to clear away the refrigerant in the system when maintaining or scrapping an air conditioner. Be aware that refrigerants may not contain an odour.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.Unit operation limits: Outdoor side 61~110 , 80%RH; indoor side 61~90 , 80%RH.

R32

Refrigerant Capacity(Btu) Room Area2Above 4m2Above 4m

2Above 15m2Above 25m

Page 5: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

3

7

8

Page 6: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

4

Crosley Corporation

Page 7: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

5

23" to 36"584 mm to 914 mm

14 1/2" min(368mm)OFFSETSTOOL

SILL

INTERIORWALL

EXTERIORWALL

FIG. 1

6 84

Page 8: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

6

(Suggest to keep a downward oblique, to let accumulated rain water to drain out, from back side of the unit bottom.)

8

5

76

Page 9: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

7

FIG. 9

9

10

FIG. 10

FIG. 11 FIG. 12

FIG. 13

FIG. 14

4

Page 10: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

8

INSTALLATION & ASSEMBLY INSTRUCTIONSIntroduction to Refrigerants R32

The maximum charge and the required minimum floor area 3 3 3m = (4 m ) x LFL , m = (26 m )) x LFL, m = (130 m )x LFL1 2 3

3 3Where LFL is the lower flammable limit in kg/ m , R32 LFL is 0.306 kg/ m .For the appliances with a charge amount m < M m :1 2

(5/4) 1/2The maximum charge in a room shall be in accordance with the following:m = 2.5 x (LFL) x h x (A)max 0

The required minimum floor area Amin to install an appliance with refrigerant charge M (kg)(5/4) 2shall be in accordance with following: A = (M/ (2.5 x (LFL) x h )) min 0

Where:m is the allowable maximum charge in a room, in kg;max

M is the refrigerant charge amount in appliance, in kg;Amin is the required minimum room area, in m2;

2A is the room area, in m ;3LFL is the lower flammable limit, in kg/m ;

h is the installation height of the appliance, in meters for calculating m or A , 1.8 m for wall mounted;0 max min

Table GG.1 Maximum charge (kg)

CategoryLFL

3 (kg/m )h0

(m)

2Floor area(m )

CategoryLFL

3 (kg/m )h0

(m)

Charge amount (M) ( kg)

2Minimum room area(m )

2Table GG.2 Minimum room area (m )

Before installing the appliance, you must read the manual carefully to get the safety information and notes.When filling the combustible refrigerant, any of your rude operations may cause serious injury or injuries to human body or bodies and object or objects.A leak test must be done after the installation is completed.It is a must to do the safety inspection before maintaining or repairing an air conditioner using combustible refrigerant in order to ensure that the fire risk is reduced to minimum.It is necessary to operate the machine under a controlled procedure in order to ensure that any risk arising from the combustible gas or vapor during the operation is reduced to minimum.Requirements for the total weight of filled refrigerant and the area of a room to be equipped with an air conditioner (are shown as in the following Tables GG.1 and GG.2)

Page 11: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

9

INSTALLATION & ASSEMBLY INSTRUCTIONS

Introduction to Refrigerants R321. Site Safety

2. Operation Safety

Open Flames Prohibited Ventilation Necessary

Open Flames Prohibited

Mind Static Electricity Must Wear Protective Clothing and anti-static gloves Don't use mobile phone

3. Installation Safety

Refrigerant Leak Detector

Appropriate Installation Location

The left picture is the schematic diagram of a refrigerant leak detector.

Please note that:

1. The installation site should be in a well-ventilated condition.

2. The sites for installing and maintaining an air conditioner using Refrigerant R32 should be free from open fire or welding, smoking, drying oven or any other heat source higher than 548 which easily produces open fire.

3. When installing an air conditioner, it is necessary to take appropriate anti-static measures such as wear anti- static clothing and/or gloves.

4. It is necessary to choose the site convenient for installation or maintenance wherein the air inlets and outlets of the indoor and outdoor units should be not surrounded by obstacles or close to any heat source or combustible and/or explosive environment.

5. If the indoor unit suffers refrigerant leak during the installation, all the personnel should go out till the refrigerant leaks completely for 15 minutes. If the product is damaged, it is a must to carry such damaged product back to the maintenance station and it is prohibited to weld the refrigerant pipe or conduct other operations on the user's site.

6. It is necessary to choose the place where the inlet and outlet air of the indoor unit is even.

7. It is necessary to avoid the places where there are other electrical products, power switch plugs and sockets, kitchen cabinet, bed, sofa and other valuables right under the lines on two sides of the indoor unit, and also prevent mechanical damage from occurring.

Page 12: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

10

To direct the airflow,horizontal wheel to control the horizontal direction, air deflector to control the verticaldirection.

horizontal wheelair deflector air deflector

Page 13: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

11

FIG. 15

15

Page 14: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

12

Page 15: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

13

Page 16: VATM05B1...8 INSTALLATION & ASSEMBLY INSTRUCTIONS Introduction to Refrigerants R32 The maximum charge and the required minimum floor area m = (4 m33 3) x LFL , m = (26 m)) x LFL, m

Your air conditioner is covered by a limited warranty provided by Crosley Corporation. Crosley has authorized CrosleyCare authorized servicers to perform the service under this warranty. Crosley authorizes no one else to change or add to any of these obligations under this limited warranty. Any obligations for service and parts under this limited warranty must be performed by an authorized CrosleyCare servicer. For one year from your original date of purchase, Crosley will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions

.

Please see warranty information packed with product or ask the dealer for complete warranty details.

Exclusions – This limited warranty does not cover the following: 1. Products with original serial numbers that have been removed, altered or cannot be readily determined. 2. Product that has been transferred from its original owner to another party or removed outside the USA. 3. Rust on the interior or exterior of the unit. 4. Products purchased "as-is".5. Removal and/or installation of the product to provide service. 6. Products used in a commercial setting. 7. Service calls which do not involve malfunction or defects in materials or workmanship, or for appliances not in ordinary household use or used other than in accordance with the provided instructions. 8. Service calls to correct the installation of your appliance or to instruct you how to use your appliance. 9. Expenses for making the appliance accessible for servicing, such as removal of trim, cupboards, shelves, etc., which are not a part of the appliance when it is shipped from the factory. 10. Service calls to repair or replace appliance light bulbs, air filters, water filters, other consumables, or knobs, handles, or other cosmetic parts. 11. Surcharges including, but not limited to, any after hour, weekend, or holiday service calls, tolls, ferry trip charges, or mileage expense for service calls to remote areas, including the state of Alaska. 12. Damages to the finish of appliance or home incurred during installation, including but not limited to floors, cabinets, walls, etc. 13. Damages caused by: services performed by unauthorized service companies; use of parts other than genuine Crosley parts or parts obtained from persons other than authorized service companies; or external causes such as abuse, misuse, inadequate power supply, accidents, fires, or acts of God.

DISCLAIMER OF IMPLIED WARRANTIES; LIMITATION OF REMEDIES CUSTOMER'S SOLE AND EXCLUSIVE REMEDY UNDER THIS LIMITED WARRANTY SHALL BE PRODUCT REPAIR OR REPLACEMENT AS PROVIDED HEREIN. CLAIMS BASED ON IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO ONE YEAR OR THE SHORTEST PERIOD ALLOWED BY LAW, BUT NOT LESS THAN ONE YEAR. CROSLEY SHALL NOT BE LIABLE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SUCH AS PROPERTY DAMAGE AND INCIDENTAL EXPENSES RESULTING FROM ANY BREACH OF THIS WRITTEN LIMITED WARRANTY OR ANY IMPLIED WARRANTY. SOME STATES AND PROVINCES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, OR LIMITATIONS ON THE DURATION OF IMPLIED WARRANTIES, SO THESE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. THIS WRITTEN WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY ALSO HAVE OTHER RIGHTS THAT VARY FROM STATE TO STATE. If You Need Service Keep your receipt, delivery slip, or some other appropriate payment record to establish the warranty period should service be required. If service is performed, it is in your best interest to obtain and keep all receipts. Service under this warranty must be obtained by contacting CrosleyCare at the addresses or phone numbers below. This warranty only applies in the USA. Your appliance is warranted by Crosley / CrosleyCare. Crosley authorizes no person to change or add to any obligations under this warranty. Obligations for service and parts under this warranty must be performed by CrosleyCare or an authorized service company. Product features or specifications as described or illustrated are subject to change without notice.

CrosleyCare Service 1-844-CROSLEY (276-7539) 3 Sperry Road Fairfield, NJ 07004

For service contact:

www.conservatorappliances.com


Recommended