Date post: | 30-Mar-2016 |
Category: |
Documents |
Upload: | vibe-audio |
View: | 235 times |
Download: | 6 times |
2
OWNERS MANUAL
-
WARNING
ATTENTION
3
LIMITED WARRANTY
www.vibeaudio.co.uk/warranty
WHAT IS NOT COVERED
INTERNATIONAL WARRANTY
www.vibeaudio.co.uk/warranty
WARNING
COPYRIGHT-
-
4
MOUNTING GUIDELINES
POWER CONNECTIONS
POWER CABLE
Chassis ground
Remote turn on
Fuse close to battery
Battery
5
CONNECTIONS
GROUND CABLE
REMOTE TURN ON CABLE
RCA CABLES
Length of Rung
Current demand 0 – 4 Ft 4 – 7 Ft 7 – 10 Ft 10 – 13 Ft 13 – 16 Ft 16 – 19 Ft 19 – 22 Ft 22 – 28 Ft
0–20 amps 14 12 12 10 10 8 8 8p
20–35 amps 12 10 8 8 6 6 6 4p
35–50 amps 10 8 8 6 4 4 4 4p
50–65 amps 8 8 6 4 4 4 4 2p
65–85 amps 6 6 4 4 2 2 2 0p
85–105 amps 6 6 4 2 2 2 2 0p
105–125 amps 4 4 4 2 0 0 0 0p
125–150 amps 2 2 2 0 0 0 0 0p
AWG to Metric and Imperial Conversion Chartcross sectional area
mmmmhcnIrebmuNGWAWW 2
5.3552.8523.004.2453.7982.016.3345.6852.027.6238.5922.031.1291.5402.048.6126.4281.053.3111.4261.065.0166.3441.0763.862.3821.0836.619.2411.0962.595.2201.001
4 – 7 Ft 7 – 10 Ft 10 – 13 Ft 13 – 16 Ft 16 – 19 Ft 19 – 22 Ft 22 – 28 F
12 12 10 10 8 8
10 8 8 6 6 6
8 8 6 4 4 4
8 6 4 4 4 4
6 4 4 2 2 2
6 4 2 2 2 2
4 4 2 0 0 0
2 2 0 0 0 0
6BlackAir Stereo 4
TERMINALS AND CONNECTIONS
1. Front low level input
2. Rear low level input
3. Front gain control
4. Front crossover frequency control
5. Rear gain control
6. Rear crossover mode select switch
7. Crossover frequency control
8. Power / protect LED
9. Speaker terminals
10. Power terminals
1091 2 3 4 5 6 7 8
7BlackAir Stereo 4
4 CHANNEL WIRING CONFIGURATION
3 CHANNEL WIRING CONFIGURATION
per channel
per channel
per channel
8BlackAir Bass 1
TERMINALS AND CONNECTIONS
1. Power / protect LED
2. Remote control input socket
3. Low level input
4. Bass boost select switch
5. Gain control
6. Crossover frequency control
8. Speaker terminals
9. Power terminals
1 2 3 4 5 6 7 8 9
9BlackAir Bass 1
SINGLE SUBWOOFER WIRING CONFIGURATION
DUAL SUBWOOFER WIRING CONFIGURATION
impedance
10
SETUP GUIDE
following setup routine:
The setting of the crossover will depend on what kind of speaker you are installing.
Note: The smaller the speaker, the less bass it can handle.
Note: By using the crossovers correctly you will not only lengthen the life of your speakers but you will also get better performance from them.
SPECIFICATIONS
UK TECHNICAL ENQUIRIES
INTERNATIONAL TECHNICALENQUIRIES
www.vibeaudio.co.uk/contact
Call 09067031420
STEREO 4STEBLACKAIRBASS 1B
Type
4 channel mono bass amp
2.1” (54mm) 2.1” (54mm)
13” (329mm) 11.1” (282mm)
6.5” (165mm) 6.5” (165mm)
4 N/A
4 N/AMono 2Mono N/AMono N/A N/A
60A 50A
20Hz - 20kHz 10Hz - 500Hz Type L / H L / SUBSONIC
0Hz - 750Hz 0Hz - 220HzModel code: BLACKAIRS4-V1 BLACKAIRB1-V1
11