Date post: | 19-May-2015 |
Category: |
Self Improvement |
Upload: | amitmittal811 |
View: | 2,347 times |
Download: | 1 times |
Vitesse 201Installation Guide
Vitesse 201Vitesse 201Installation Installation
GuideGuide
SMC Enterprises Private LimitedManufacturer: Vitesse Vending Machines
Distributors: Georgia Gold Coffee, Burn Energy Drink, Apeejay Typhoo Tea,
Parle Agro, Godrej Vending Machines, Del-Monte.Branches at: Delhi, Noida and Gurgaon
Contact us on 9811225804Email: [email protected]
www.VendingMachine.in
Unpacking the Machine
Cut the TAPE with a sharp knife.Do not push the knife too hard.Cut both side.
Unpacking the Machine
Hold the Machine and turn the Flaps outside of the box.Do this with all four Flaps
Unpacking the Machine
Pull out the Packing box.Pull out the Protective covering.Do not use any sharp object to do this.
Unpacking the Machine
The Machine has Stainless Steel Top and Bottom which means longer its life.The Drainage pipe is packed inside the Stainless steel Drip tray.
Unpacking the Machine
Please stand the machine on a Plane surface.There must be a Gap of four (4) Inches between the machine and the nearest wall.
Unpacking the Machine
Keys of the machine are attached with the power cord.Cut the tie carefully and detach the keys.
Filling Premixes in the Canisters
Filling Premixes in the Canisters
Push the canister upwards then pull out.
Filling Premixes in the Canisters
Turn the Elbow spout upwards to not let the Premix get waste.
Filling Premixes in the Canisters
Pour the premix in the canister slowly.DO NOT OVEFILL the Canisters
Filling Premixes in the Canisters
Re-cap the canister properly after filling.Please Re-cap the canisters after every filling.
Filling Premixes in the Canisters
There is a male groove in the machine and a female groove on the Canister.Please match them (male to female) when fixing the canisters.
Filling Premixes in the Canisters
Fix the Canisters properly.Turn the elbow spouts downwards to the mixing bowls.
Installation of the Machine
Switch on the Machine only after Putting the Water bottle on the Top.
Installation of the Machine
When the heating indicator is on it means the machine is getting ready.When it's off Machine is ready to serveThe temperature of Dispenses can be controlled Manually.
Heating Indicator
Temperature controller
Machine is ready to serve when the
indicator is off
Installation of the Machine
Put the cup on the located place.Select your Choice.
Installation of the Machine
Please Do not touch the dispenses they are extremely hot.Grab your cup.