Date post: | 15-Jan-2016 |
Category: |
Documents |
Upload: | collin-hoover |
View: | 216 times |
Download: | 0 times |
Ways of pulse shaping (found to be ineffective):
Cut-offSpectral overlap
OPTIMIZATION OF FEMTOSECOND TWO-PHOTON STORAGE BY SPECTRAL PULSE SHAPINGN.S. Makarov, A. Rebane, M. Drobizhev; Department of Physics, Montana State University, Bozeman, MT 59717, USA
FAX: (406)-994-4452, Phone: (406)-994-7827, E-mail: [email protected]
(A) 2-dimensional optical storage medium; (B) 3-dimesional optical storage medium; (C) Addressing of data bits in 3-dimensional optical storage medium. Laser beam (1) from a pulsed laser (not shown) is
focused with a large numerical aperture lens (2). The laser focus considers exactly with one volume bit (voxel) (3) at a time
Dependence of reduced SB ratio on writing frequency at different values of Lorentzian width of 1PA profile
One-photon absorption (Q1-band) Two-photon absorption Photochemical reaction 1
0 (cm2)
max (nm)
cm-1)
1cm-1)
R (ns)
cm-1)
2cm-1)
20
(cm4s) A,B
B 4.8310-16 750 380 50 50 800 160 7.210-46 1.110-3 A n/a 730 n/a n/a n/a n/a n/a n/a 810-3
Parameters of simulations:
One-photon excitation
Two-photon excitation
S ~ 1 I
S ~ 2 I2
One- and two-photon excitation
Problem: Model:
Results:
CONCLUSIONS
• We theoretically study the possibility to use organic chromophores for rewritable ultrafast TB data storage. Our model estimations and computer simulations of signal-to-background and signal-to-noise ratio demonstrate that, while the requirements placed upon a particular set of material parameters are extremely stringent, we can indicate their best combination, which could allow for rewritable TB storage.
• Since this problem is rather complicated because of many undefined parameters, further work is needed. Namely, more simulations, which would consider different spectral shapes of long-wavelength tail, for example, exponential (Boltzmann or Urbach), as well as different spectral shapes of 2PA are required.
REFERENCES
1. D.A. Parthenopoulos, P.M. Rentzepis, “Three-Dimensional Optical Storage Memory”, Science, 245, 843-845 (1989).
2. G.W. Burr, Volumetric storage in Encyclopedia of Optical Engineering, ed., R.B. Johnson and R.G. Driggers, Marcel Dekker, New York, 2003.
3. J.H. Strickler, W.W. Webb, “Three-Dimensional Optical Data Storage in Refractive Media by Two-Photon Point Excitation”, Opt. Lett., 16, 1780-1782, (1991).
4. M. Drobizhev, A. Karotki, M. Kruk, N. Zh. Mamardashvili, A. Rebane, “Drastic enhancement of two-photon absorption in porphyrins associated with symmetrical electron-accepting substitution”, Chem. Phys. Lett., 361, 504-512 (2002).
5. M. Drobizhev, Y, Stepanenko, Y. Dzenis, A. Karotki, A. Rebane, P.N. Taylor, H.L. Anderson, “Extremely strong near-IR two-photon absorption in conjugated porphyrin dimers: Quantitative description with three-essential-states model”, J. Phys. Chem. B 109, 7223-7236, (2005).
6. M. Drobizhev; A. Karotki; M. Kruk; A. Krivokapic; H.L.Anderson,; A. Rebane, “Photon energy upconversion in porphyrins: one-photon hot-band absorption versus two-photon absorption”, Chem. Phys. Lett., 370, 690-699, (2003).
7. M. Miwa, S. Juodkazis, T. Kawakami, S. Matsuo, H. Misawa, “Femtosecond Two-Photon Stereo-Litography”, Appl. Phys. A 73, 561-566, (2001).
8. S. Kershaw, Two-Photon Absorption, Chapter 7 in Characterization Techniques and Tabulations for Organic Nonlinear Optical Materials Ed. M.G. Kuzyk and C.W. Dirk, Marcel Dekker, New York, 1998.
9. R.W. Boyd, Nonlinear Optics, 2nd Ed., Chapter12, Academic Press, Amsterdam, 2003.
AB
(1)
(3)
(2)C
M – number of recorded layers
However, two competing processes are involved in writing of data:1.Two-photon excited photochemical reaction in focus spot only2.One-photon excited photochemical reaction in all laser beam
In case of many layers (M>100) Signal-to-Background Ratio (SBR) is very small and it is extremely difficult to read out written data. The solution is to optimize writing pulse spatial/temporal profile and frequency to increase SBR.
The other problem is that only small part of molecules in focusing volume is transformed by photochemical reaction into written form, and at reading of written information the Signal-to-Noise Ratio (SNR) is small, that cause the low efficiency of error-suppressing algorithms. The solution is not only optimization of reading parameters, but also combining two-photon- and one-photon fluorescence at confocal reading scheme.
For mode-locked Ti:Sa commercial oscillators SNR cannot exceed 2.5, while for cw-laser in confocal geometry it can be up to 3.6.Both values, obtained for pulsed and cw regimes of reading are not much larger than unity, calling for further improvement of molecular parameters in order to avoid sophisticated photon-counting. First, efficiency of photochemical reaction can be considerably increased by an order of magnitude. A substantial increase of concentration is hardly possible because of aggregation problem. Also, if the aggregation is still absent, for pulsed reading, the increase of concentration will be followed by a decrease of fluorescence quantum efficiency due to Förster energy transfer. In the case of pulsed reading, one can search for molecules with larger quantum efficiency of fluorescence. In cw-reading regime, which seems more preferable than the pulsed one, the increase of oscillator strength of the first 1PA transition can also improve the SNR.
Since pulse shaping results in significant losses of pulse power, it is found to be ineffective as a method of optimization of SBR/SNR.
;
Ir,w
1,20
1,2; 1,2
p 0
Laser pulse shape
2PA/1PA absorption band shape
The actual working region of writing frequencies and intensities is determined from the following requirements:
1.Ideally, one would like to keep the power density close to 2PA saturation, but still few times lower than the thresholds of polymer damaging and other nonlinear side effects. All these processes usually start at I ≥ 1030 photon/cm2s for 100-fs pulses;
2.On the other hand, our estimation shows, that for 100-fs pulses with peak power density I ~ 31029 photon/cm2s, taken as a working intensity for writing, the saturation of two-photon transition starts when 2 approaches ~ 10-46 cm4s;
3.Operating near 2PA saturation is required for reasonable SNR so that it is required to have 2 > 10-46 cm4s. This restricts the region of frequencies to p > 2.3 rad/fs;
4.To avoid considerable pulse absorption within the layers, we need to keep 1PA cross section 1 < 7 10-18 cm2, (for a 5-mm thick disk) that restricts the working
frequencies from above: p < 2.45 rad/fs.
Photochemical 2PA reaction
Since by shaping of absorption band spectrum we cannot get rid of homogeneous broadening of spectral line, and pulse shaping decrease the power of pump pulse, in our model it is important to take into account both 2PA and 1PA.
Simulation expressions for SNR and SBR:
Signal-to-Background Ratio, essential for reliable reading of written data
Signal-to-Noise Ratio, for reading with pulsed laser
Signal-to-Noise Ratio, for reading with cw-laser
r is the repetition rate of pulsed laser, tdw is the time of reading of one bit (dwell time), R is the
radiative lifetime, f is the quantum efficiency of fluorescence, T is the quantum efficiency of
chemical reaction, N0 is the number of molecules in 1 voxel, Nr is the number of photons, collected by the detector, K is the the number of cycles of excitation - relaxation of written molecules during the dwell time , and is the quantum efficiency of collection of photonsP1,2(w, Iw) is the probability of molecule to transform into the written form, calculated as:
Reduced Signal-to-Background Ratio, used in simulations:
MIP
IPSBR
ww
ww 1,,
1
2
fdwTr rtNNSNR 0max 5.0
RdwTr tNNSNR /5.0 0max
dIP pp 11 ,
dttIP pp2
22 21
01
1011
gg
02
2
2
0
022
gg
'
' 222,1
2
'
2,1
22,1
20
de
g
ww
ww
IPIP
SB,,
1
2
frrrrTwwr KIPIPNIPN ),(),(),( 2102
Erasure of written data Other competing processes to worry about
Dependence of reduced SB ratio on writing frequency at different values of Gaussian width of 1PA profile