Lexium MDrive EthernetWindows Firewall configuration for Ethernet firmware upgradeApplication NoteV1.00, 01.2015
Copyright © Schneider Electric Motion USA, All Rights Reserved
Lexium MDrive Application Note
Date Revision Changes
01/25/2015 V1.00, 01.2015 Initial release
Windows Firewall configuration for Ethernet firmware upgrade
The Lexium MDrive Ethernet TCP/IP Configuration Utility uses TFTP (Trivial File Transfer Protocol) to upgrade the firmware application code for the Ethernet controller.
As TFTP runs as a server for the process, it is essential that UDP port 69 be opened to allow both incoming and outgoing traffic on Windows Firewall for the upgrade process to complete successfully.
In the case that your IT department doesn’t allow Windows Firewall set-ting to be adjusted, or that another, third party firewall is in use, request that UDP Port 69 be unblocked, or, perform the upgrade using PC exter-nal to your corporate network.
Configure Windows Firewall to unblock UDP Port 69
X Open the Windows Control Panel
X Open Windows Firewall
X Click “Advanced Settings.”
Figure 1: Windows Firewall home screen
Create an Inbound Rule
X On the Advanced Settings screen, select “Inbound Rules”
Figure 2: Windows Firewall - Inbound Rules
X On the right column of the screen, select “New Rule.” The New Inbound Rule Wizard dialog will open.
X Select the radio selector labeled “Port” to define the Rule Type as applicable to a port. Click Next.
Figure 3: New Inbound Rule Wizard
X On the Protocols and Ports dialog, activate the radio selector labeled “UDP”
X Select the option “Specific Local Ports.” In the text field, enter the number “69”. Click Next.
Figure 4: Protocol and Ports dialog
X On the Action dialog select the option “Allow the connection” Click Next.
Figure 5: Action dialog
X On the Profile dialog, check the networks to which this rule will apply. Click Next.
Figure 6: Network Profile dialog
X Name the rule “SEM Ethernet Upgrade.” Clck Finish.
Figure 7: Rule name
X In Windows Firewall Advanced settings screen the new rule will show as active.
Figure 8: Inbound Rule configuration complete
Create an Outbound Rule
X On the Widows Firewall Advanced Settings screen, select Out-bound Rules.
X On the right column Click “New Rule.”
X Repeat the steps for the Outbound Rule Wizard as followed in creating the Inbound Rule, configuring the firewall to allow outbound traffic on UDP Port 69.
X You may now continue with the process of upgrading Ethernet firmware. When complete SEM recommends that you disable the rules.
© Schneider Electric Motion USA All Rights Reserved. Product Disclaimer and most recent product information online.
Schneider Electric Motion USA 370 N. Main Street Owing to changes in standards and equipment, the characteristics given in the text and images Marlborough, CT 06447 USA in this document are not binding until they have been confirmed with us. Print: Schneider Electric Motion USA www.motion.schneider-electric.com Photos: Schneider Electric Motion USA
Last update : 01 / 26 / 2015
USA SAlES officES East Region Tel. 610-573-9655e-mail: [email protected] RegionTel. 860-368-9703e-mail: [email protected] Region Tel. 630-267-3302 e-mail: [email protected] Region Tel. 602-578-7201 e-mail: [email protected]
EURoPEAN SAlES MANAGEMENTTel. +33/4 7256 5113 – Fax +33/4 7838 1537 e-mail: [email protected]
TEcHNicAl SUPPoRT Tel. +00 (1) 860-295-6102 – Fax +00 (1) 860-295-6107e-mail: [email protected]