Wireless G PCi Card quiCk install Guide Model 524575

INT-524575-QIG-0209-01

2

Thank you for purchasing the INTELLINET NETWORK SOLUTIONS™ Wireless G PCI Card, Model 524575.This quick install guide presents the rudimentary steps required to set up and operate this device. For more detailed instructions and specifications, refer to the user manual 1) on the CD enclosed with this product; 2) on the Web site listed below; or 3) in some cases, printed and enclosed with this product. Contact your INTELLINET NETWORK SOLUTIONS dealer with comments or questions, or visit www.intellinet-network.com for information on the latest software and firmware updates, related products and additional contact information.

NOTE: Instructions and screen images for both the Hardware and Software Installation sections are representative of Windows XP, but are similar for Windows Vista. Some screen images have been modified to fit the format of this guide.

hardWare installation1. Turn off computer and remove its cover. 2. Firmly insert the Wireless G PCI Card into an available PCI slot on the motherboard. 3. Secure the card to the rear of the computer chassis.4. Replace the cover.5. Secure the antenna to the connector on the card and adjust the position of the antenna as needed.6. Turn the computer on.

softWare installation1. Place the included installation CD in your CD-ROM drive. NOTE: If your operating system displays the Found New Hardware screen, click “Cancel.”2. On your computer’s desktop, go to My Computer, click on the installation CD icon, then click/select “Setup.exe.”3. When the Choose Setup Language screen displays, make a selection and click “Next.” When the subsequent screen displays, click “Next.”

4. When the Installation screen displays, click “Install.”

3

5. The InstallShield Wizard will begin to install the necessary software. A Setup Status screen displays to indicate the installation progress.

6. If your operating system displays a compatibility notice, click “Continue Anyway” and proceed with the installation.

4

7. When the InstallShield Wizard Complete screen displays, the installation is complete. Select “Yes, I want to restart my computer now,” then click “Finish” to reboot your computer.

Zero Configuration Tool for Windows XPThe Windows Zero Configuration Tool helps you set up the Wireless G PCI Card. 1. Right-click the icon in the system tray (as shown at right) to open the Zero Configuration Tool.

5

2. In the pop-up menu, double-click “View Available Wireless Networks.”3. When the Choose a Wireless Network screen displays, click to highlight the desired option, then click “Connect.”

Zero Configuration Tool for Windows VistaThe Windows Zero Configuration Tool helps you set up the Wireless G PCI Card. 1. Right-click the icon in the system tray (as shown at right) to open the Zero Configuration Tool.

6

2. In the pop-up menu, double-click “Connect to a Network.”3. When the Connect to a Network screen displays, click to highlight the desired option, then click “Connect.”

7

INTellINeT NeTWoRK SolUTIoNS™ offers a complete line of active and passive networking products.

Ask your local computer dealer for more information or visit

www.intellinet-network.com.

Copyright © INTELLINET NETWORK SOLUTIONSAll products mentioned are trademarks or registered trademarks of their respective owners.