1

• To propose : Wireless Lease Line services for Ebworx Berhad.( Tower 1 Jaya 33).

• Equipment used : 1 set Unii & ISM band wireless bridge;: 1 unit 3mm x 2 inc x 5 Feet pole.

Location involved : Rooftop area; : 9th floor telephone riser to 5th floor telephone riser; : 5th server room.

• Project duration : 5 days (Cabling, Wireless Transceiver Setup and Fine Tuning)

• Prepared By : Affendi

• Account Manager : Mr Looi.

• Company Address :Block H-08-01 Setia Walk, Persiaran Wawasan, Pusat Bandar Puchong, 47100 Puchong, Selangor, Malaysia

Wireless Lease Line services for EBworx Berhad.

Antenna “A”:* shown antenna “A,” is to point Mykris POP* Shown antenna is for proposal purpose, the actual dimension may will different.* For the antenna detail, please refer to the antenna page.

Wireless Transceiver:* The wireless transceiver antenna “A” will install at the rooftop.

Data cable:* There will 1 SFtp cable from the wireless transceiver to the Server. The Sftp cable is running on the POE to supply the DC to the wireless transceiver..

5 Feet Pole:* The 5 Feet pole will attached to the wall as indicated.

Antenna Location(rooftop)

Antenna Location(rooftop)

A

Rooftop area

Antenna “A”:* shown antenna “A,” is to point Mykris POP* Shown antenna is for proposal purpose, the actual dimension may will different.* For the antenna detail, please refer to the antenna page.

Wireless Transceiver:* The wireless transceiver antenna “A” will install at the rooftop.

Data cable:* There will 1 SFtp cable from the wireless transceiver to the Server. The Sftp cable is running on the POE to supply the DC to the wireless transceiver..

5 Feet Pole:* The 5 Feet pole will attached to the wall as indicated.

Wireless Lease Line services for EBworx Berhad.

Staircase 9th floor telephoone riser

Antenna “A”:* shown antenna “A,” is to point Mykris POP* Shown antenna is for proposal purpose, the actual dimension may will different.* For the antenna detail, please refer to the antenna page.

Wireless Transceiver:* The wireless transceiver antenna “A” will install at the rooftop.

Data cable:* There will 1 SFtp cable from the wireless transceiver to the Server. The Sftp cable is running on the POE to supply the DC to the wireless transceiver..

5 Feet Pole:* The 5 Feet pole will attached to the wall as indicated.

Wireless Lease Line services for EBworx Berhad.

5th floor Server room5th floor telephone riser

5

MyKRIS iGate Wireless Bridge Link Budget Calculation

Link to MyKRIS POP Statistic:

66

MyKRIS Cabling IP56 PVC Conduit Technical Specification

77

MyKRIS iGate Wireless Bridge SIRIM Type Approval Certification

MyKRIS Multi-Homing With Microwave Link Network Coverage Plan

Microwave Link 360Mbps

Microwave Link 360M

bps

Micr

owave L

ink 360Mbps

9

-Mykris Wireless lease line setup is based on Point-to-Point setup.-Mykris Wireless lease line is based on the MPLS network topology.-Mykris Wireless lease line is based on the TDMA wireless protocol.

MyKRIS iGate Wireless Bridge Delivery Plan

10

MyKRIS iGate Wireless Bridge Antenna Selection

11

MyKRIS iGate Wireless Bridge Technical Specification

12

Mykris Wireless iGate System MPLS Overview:

The MPLS/VPLS approach has some advantages:

- MPLS MTU is running on 1522, this to avoid fragmentation if packet size + VPLS CW + MPLS labels exceeds MPLS MTU of outgoing interface.- VPLS tunnel is about 60% faster and less overhead than common IEEE 802.11 WDS setup.- IEEE 802.11 speed is limited over WDS bridges, this method doesn't have such limitations.

Advance Security of the Mykris Wireless iGate System MPLS over wireless setup:- LDP transport address is based on point-to-point subnet = /30.- Allow authorized LDP transport address to communicate.- Unique VPLS ID is invisible in the wireless environment.- Allow authorized VPLS interface to communicate.- Allow authorized VPLS ID to communicate.

MyKRIS iGate Wireless Bridge Communication Protocol

13

MyKRIS iGate Wireless Antenna Technical Specification