Wrought iron electric sliding gates

Sliding gates are generally used at the ends of driveways, or other areas where swing gates would block a road when opened or are just not feasible due to space restrictions.

North Valley Forge offers a wide range of sliding gate options, including conventional or cantilever types to suit both domestic and commercial purposes.

The oldest type is the conventional sliding gate with wheels on the bottom frame and a floor track to run on, all the way across the entrance and as much again for the gate to fully open and close.

More recently, to avoid disrupting driveways, cantilever types have proved more popular, as all that is really needed is a concrete foundation block to mount the carriages to, which run in a track welded to the bottom of the gate. With a calculated overhang to balance the gate, it will fully open and close without the need for anything in the floor.

OUR SLIDING GATES

UNDER THE BONNET

Either type of sliding gates can be automated and if so, can be opened manually in the event of a power failure. (See our Gate Automation category for further information)

Why not call us with your requirements and we would provide the best possible solution for you.

Safety is of paramount importance especially where Electric Sliding Gates are concerned and we off a full risk assessment, either carried out on site or from images if remote, advising on the most comprehensive solution required.

All forms of Access Control such as Intercoms, Ground Loops, Keyfobs etc. can be added to complete a safe, convenient Automated Sliding Gate System, to suit your exact needs.

http://www.gatesiron.com

North Valley Forge Valley: 01282-677 300

North Valley Forge (Midlands): 0121-553 0799

You can request a free brochure and go through our products when you call us.

For More Information