Summary MMU version of Kermit the Frog, a Muppet character by Jim Henson. Kermit serves as the straight man protagonist of numerous Muppet productions, most notably Sesame Street and The Muppet Show, as well as in other television series, films, specials, and public service announcements through the years. In order to make this model fully support free, this is a two piece model (head, body). See important print instructions for a six color model! The height of the assembled model is 60mm. This MMU model was derived from my non-MMU model (reworked for a clean MMU print): https://www.prusaprinters.org/prints/211-kermit Enjoy, and don't forget to post your makes! Toys & Games > Action Figures & Statues muppet frog comics cartoon There are two 3MF files attached. One for just the head and one for the body. reddadsteve Kermit the Frog - MMU VIEW IN BROWSER updated 7. 7. 2019 | published 7. 7. 2019 3D MODEL ONLY
Transcript
Summary
MMU version of Kermit the Frog, a Muppet character by Jim Henson.
Kermit serves as the straight man protagonist of numerous Muppetproductions, most notably Sesame Street and The Muppet Show, as well asin other television series, films, specials, and public serviceannouncements through the years.
In order to make this model fully support free, this is a two piece model(head, body). See important print instructions for a six color model!
The height of the assembled model is 60mm.
This MMU model was derived from my non-MMU model (reworked for aclean MMU print):
https://www.prusaprinters.org/prints/211-kermit
Enjoy, and don't forget to post your makes!
Toys & Games > Action Figures & Statues
muppet frog comics cartoon
There are two 3MF files attached. One for just the head and one for thebody.
Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES
640.8 KBupdated 7. 7. 2019
2.7 MBupdated 7. 7. 2019
2.8 MBupdated 7. 7. 2019
6.1 MBupdated 7. 7. 2019
8.1 KBupdated 7. 7. 2019
The head contains five colors and the body contains two colors (with onerepeat color from the head). If you print the head separately from the bodyyou will get a six color print.
If you load both 3MF files and print the head and body at the same time,you need to decide which color will be duplicated. My wife suggests thatthe ruff must stay yellow, so the suggestion is to make the white part ofthe head (eyes) in yellow also.
I've also included all the STL files.
All the supplied files are for the smallest recommended size of the model.The model can be sized up without issue, but I would not recommendsizing it down any further.
![MMU - Texas EMTFtxemtf.org/wp-content/uploads/2019/09/MMU-FINAL.pdf · MMU Tent Structure for 32+ Beds, 53’ MMU Command Trailer MMU Supply, Pharmacy, & Diagnostic Equipment [2]](https://static.documents.pub/doc/80x56/5eb70ed4759f960e1f5063e5/mmu-texas-mmu-tent-structure-for-32-beds-53a-mmu-command-trailer-mmu-supply.jpg)
