3
INSTALLATION INSTRUCTIONS YAMAHA Raptor 700 To avoid injury or damage to your ATV, read and understand these instructions completely before installation. 1. Parts List: Ite m Part Name Description Qty 1 Nerf Bar Left 1 2 Nerf Bar Right 1 3 M6 X 16mm Bolt Hex Head 1 4 M8 X 25mm Bolt Hex Head 4 5 M8 Nut Nylock 6 6 M8 Washer Flat Washer 10 7 M8 X 30mm Bolt Flange Head 2 8 M6 Nut Nylock Nut 1 9 Web Set (1) Left & (1) Right 1 10 Loose Web Clips Frame Web Clips 6 11 1/4” spacer Large Washer 2 2. Preparation: a) Set/Lock rear parking brake on bike, and stand bike upright so that it is sitting on the rear grab bar. Make sure vehicle is secure and will not fall over while installing the Nerf Bar. 3. Installation: a) Set Left Nerf Bar in place and attach forward mount with Items #5, 7, 11. b) Attach rear mount with Items #4, 5, 6. c) Insert Right Nerf Bar Tube into the Left Nerf Bar. d) Attach rear mount on right side using same procedure as the left. e) Install (1) M6 Nut Item #8 onto (1) M6 Bolt Item #3 and install into "threaded hole" in Left Front Nerf Bar Bracket / Tube until it bottoms out against the "inside" Right Nerf Bar Tube. With wrench on (1) M6 Bolt Item #3, turn (1) M6 Nut Item #8 counter clockwise until it stops against the threaded Nerf Bar Bracket
