YK2000i DIGITAL GENERATOR

OWNERS MANUALPLEASE BE SURE TO READ THIS MANUAL BEFORE STARTING YOUR GENERATOR

SHANGHAI YANGKE ENGINE CO., LTD.1

SAFETYBE CAREFUL!

NO USE IN HOUSE!

NO USE IN WET CONDITION

NO CONNECT TO HOUSEHOLD CIRCUIT

2

KEEP IN FLAMMABLE AWAY

WHEN REFUELING:

STOP ENGINE

NO SMOKING

DO NOT SPILL

3

START ENGINE1. Engine switch to the ON position and move the choke lever to CLOSE. Turn the Fuel Valve to the ON position.

2. Pull the starter grip lightly until resistance is felt, then pull briskly.

3. Move the choke lever to OPEN as the engine warms up.

4

USE GENERATOR AC APPLECATION

1. Make sure the pilot lamp comes on.

2.Plug in the appliance.

5

DC APPLECATION

NOTEThe DC terminals may be used for charging 12 volt automotive-type batteries only. 1. Connect the charging cables to the battery terminals and then to the DC terminals of the generator. Connect the and the terminal of the battery to the DC terminal terminal of the battery to the DC terminal.

2. Set the engine switch to ON and start the engine.

6

STOP ENGINE

1. Disconnect the electrical appliance.

2. Turn the engine switch to the OFF position.

3. Turn the fuel valve off.

7

SPECIFICATIONSType Rated Speedr/min Rated PowerW Max PowerW Rated VoltageV FrequencyHz Rated CurrentA NoisedB7m Volt fluctuating Rate% Volt adjusting rate% Frequency adjusting Rate% Fuel consumptionkg/h Type Rated PowerW DisplacementCC Dimensionmm N.W./G.Wkg Engine Generator YK2000i 4500 1500 1600 220/230/240 50/60 6.8 75 No 5 Invariableness 0.88 YK156F 2000 98 590375460 21/23

8

MAINTENANCE

Unscrewing a maintenance cover screw and remove the maintenance cover.

AIR CLEANER

1. Open the air cleaner cover.

2. Check for dirt in the air cleaner element, if it is dirty.

9

CHECK OIL EVENRY MORNING

10

CHANGE THE OIL AFTER THE FIRST MONTH OR AFTER 20 HOURS, WHICHEVER COMES FIRST. AFTER THIS EVERY 6 MONTHS OR 100 HOURS, WHICHEVER COMES FIRST.

11

TROUBLE SHOOTING ENGINE NOT START1.CHECK FUEL

2.CHECK OIL

3.CHECK SPARK REMOVE PLUG

4.ENGINE SWITCH ON

12

5.CHECK SPARK

NO ELECTRISITY

CHECK INDICATOR 1. If the OVER LOAD lamp comes on.

2. Stopping the engine.

3. Restarting the engine.

13