+ All Categories
Home > Business > Zebra K420d

Zebra K420d

Date post: 09-Aug-2015
Category:
Upload: joe-leggett
View: 208 times
Download: 0 times
Share this document with a friend
Popular Tags:
11
ZEBRA GK420D “PASS REMOVAL AND DISTRIBUTION” OHCC PATROL PRESENTS
Transcript

ZEBRA GK420D“PASS REMOVAL AND

DISTRIBUTION”

OHCC PATROLPRESENTS

The ZEBRA GK420d

This is the Zebra GK420d in “neutral” mode. The Zebra GK420d is used to print passes for guests, vendors, and real estate agents, allowing them to enter Ocean Hills Country Club. It is sometimes used to print passes for residents (i.e. new residents or residents with new cars).

REMOVING THE PASS(STEP ONE)

After locating the correct information for the guest, vendor, or real estate agent, use the mouse, located at the right hand side of the keyboard , to select “print.” Remove your right hand from the mouse and place it on the Zebra GK420d. Place enough pressure on the Zebra GK420d to keep it in place throughout the entire process.

REMOVING THE PASS(STEP TWO)

After securing the Zebra GK420d with your right hand, place your left hand near the output of the Zebra GK420d and extend your thumb upwards in preparation of receiving the pass. As all hands are different sizes, it will take some practice to determine the proper placement of your hand so that the front of the pass meets the space between your thumb and forefinger.

REMOVING THE PASS (STEP THREE)

As it prints the Zebra GK420d will feed the pass into your left hand. Do not be alarmed! After the Zebra GK420d completes the printing process, gently press your left thumb down on the pass as if pinching it (see “Step Four”).

REMOVING THE PASS(STEP FOUR)

With the pass firmly in the grip of your “pinch,” continue pressing down on the Zebra GK420d with “just enough pressure” to keep it in place as you prepare to remove the pass.

REMOVING THE PASS(STEP FIVE)

Gently pull, in an even and smooth motion, the newly printed pass towards you. Be sure to use enough force to cleanly remove the pass from the Zebra GK420d. Do not remove your right hand from the Zebra GK420d until the pass is removed!

PASS DISTRIBUTION(PART ONE)

Hand the newly printed pass to the guard in charge of access control.

PASS DISTRIBUTION(PART TWO)

If no guard is present, get up from your chair and distribute the newly printed pass to the guest, vendor, or real estate agent.

ZEBRA GK420DTRAINING

Upon completion of this PowerPoint demonstration , ten “dry runs,” and a thirty question test on removing and distributing a newly printed pass from the Zebra GK420d, you will receive a certificate of completion, good for six months.

PRODUCER: JOE LEGGETT, JR.DIRECTOR: JOE LEGGETT, JR.

STARRING:THE OHCC SECURITY TEAM AND THE REMARKABLE ZEBRA GK420D.

ZEBRA GK420d“PASS REMOVAL AND

DISTRIBUTION”


Recommended