TRUE / RELATIVE WIND SPEED-DIRECTION display for Navigation Bridge and CCR. ZH 25 MFD (Multi function display) Ideal for Tankers in order to comply with the latest Exxon-Mobil MESQAC E17 Fully complies with new PANAMA CANAL requirements N-1-2018 Features: • Fully compatible with all Wind Sensors. • 5 isolated inputs/outputs RS422/RS485 • 3 outputs RS422 • 8 Inch TFT Tuch screen Display • Recording of wind speed, depth and alarm log in SD card. • Set points for Low-Low /Low Depth / High /High-High Wind. • Software update by SD • Easy Installation, console or table mound • Manual or Auto adjust of brightness • 4 Color Mode • Date and time select priority from GPS or internal clock. • Line monitor on each port. • When ZH25 MFD installed in CCR can be select “AT SEA” or “TERMINAL • When used as PANAMA CANAL display, HORN can be activated by pressing a knob only • Dual retantant supply input CCR WIND System Exon Mobil Selectable Screen True Wind Relative Wind Panama cannal Rudder Angle repeater Rate of Turn repeater Gyro repeater Speed Log repeater Echo Sounder repeater 3 Axis Doppler Log repeater ZH25 MFD
Transcript
TRUE / RELATIVE WIND SPEED-DIRECTION display for Navigation Bridge and CCR.
TRUE / RELATIVE WIND SPEED-DIRECTION
ZH 25 MFD (Multi function display)
Ideal for Tankers in order to comply with the latestExxon-Mobil MESQAC E17
Fully complies with new PANAMA CANAL requirements N-1-2018
Features:• Fully compatible with all Wind Sensors.• 5 isolated inputs/outputs RS422/RS485• 3 outputs RS422• 8 Inch TFT Tuch screen Display
• Recording of wind speed, depth and alarm log in SD card.• Set points for Low-Low /Low Depth / High /High-High Wind.• Software update by SD• Easy Installation, console or table mound• Manual or Auto adjust of brightness• 4 Color Mode• Date and time select priority from GPS or internal clock.• Line monitor on each port.• When ZH25 MFD installed in CCR can be select “AT SEA” or “TERMINAL• When used as PANAMA CANAL display, HORN can be activated by pressing a knob only• Dual retantant supply input
CCR WIND SystemExon Mobil
Selectable Screen
True Wind Relative Wind Panama cannal Rudder Anglerepeater
• Fully compatible with all Wind Sensors.• 5 isolated inputs/outputs RS422/RS485
• Recording of wind speed, depth and alarm
• Easy Installation, console or table mound
• Date and time select priority from GPS
• When ZH25 MFD installed in CCR can be select
Introduction ZH25MFD
Specifications ZH25MFD
The ZH25 MFD has 5 isolated NMEA 183 RS422/485 inputs for signals sush as WIND SENSOR, GPS, GYRO, SPEED LOG, ECHO SOUNDER, 3 AXIS DOPLER LOG etc. 3 Outputs NMEA 183 RS 422 for VDR, ECDIS. and 2 DRY CONTACT for connection SIREN-HORN and FLASH LIGHT to upper bridge. 1 USB port for printer and one isolated ETH port. for Local alarm visual and audio.
8” Touch screen color display implements a Graphical User Interface of data and saving the values of alarms in SD CARD (CSV file, Date, time, Position, type of alarm, alarm acknowledge).Dual auto redundant isolated wide input supply 24 VDc (9-36 Vdc) with reverse polarity protection. • 24VDc OUTPUT for wind sensor • Auto self diagnosis with display all alarm messages
ZH25MFD Display-Recorder comes with maximum performance capabilities, implementing monitoring and alarm function operation:
Units: Wind.Kn/Km/h/m/s Temp. C Distance.NM/Km Depth.
Doppler Mode: Water/Ground/AutoSelf Diagnosis: Serial Ports,ROM,RAM,RTCPower supply voltage: 9-36VDcPower consumption: 2.5WSupply isolation: 500VAc@1 minSupply surge protection: 200A@3mSecOutput for Wind Sensor Voltage: 24VDc Output for Wind Sensor Current: 250 maOutput for Wind Sensor Heating Voltage: 24VDcOutput for Wind Sensor Heating Current: 3ANumber of Input – Output RS422/RS485: 5Number of Output RS422: 3RS 422/485 I/O Isolation: 1000VRS 422/485 I/O 1-5 Sensitivity: 0.3VRS 422/485 I/O Input Impedance: 11KOhmRS 422/RS 485 I/O Surge protection: 60A@8,3mSecRS 422 output Voltage (open Circuit): 4.5VRS 422 output Voltage (110 Ohm Load): 3.8 VRS 485/RS 422 I/O ESD Protection : 60A@8,3mSecInput – Output Bit Rate: 115200ETHERNET 10-100 MbitUSB USB 2.0SD Cart: 64 GB maxTFT Display Size: 8 InchDisplay Angle View: U50 D70 L70 R70Display Color: 256@65kDimer level: 6 level or AutoDimensions: 220mm x 180mm x 58mmCompliance Standards: IEC 60345,IACS E10, IEC 61162
Ambient Conditions: Temp:-15-+55C, IP 20 Rel. Humidity: 0%-93%
ALARMS ZH25MFD Log file
145,00
140
,00
258,76
219
,65
5,50
Date-time Date-time source Alarm action Alarm type Value Units Ack source2020-03-15 10:41:08 G Set Depth low 6.2 Meters 2020-03-15 10:41:11 G Ack Depth C2020-03-15 10:41:11 G Clear Depth 1043.3 Meters 2020-03-15 10:43:02 G Set Wind speed very high 200.0 Knots 2020-03-15 10:43:12 G Set Wind speed high 25.0 Knots 2020-03-15 10:43:36 G Clear Wind speed 1.0 Knots
options
Introduction ZH26 BC For new installations of ZH25 MFD at CCR and ZH26BC (Bridge controller) is decremented which is installed in navigation Bridge, connected only with one screened cable 2 x 0,75 . between Navigation Bridge and CCR
The ZH26BC has 4 isolated inputs-outputs NMEA 183 RS 422/485 for GPS, WIND SENSOR, ECHO SOUND-ER, SPEED LOG, 2 Output NMEA 183 RS 422 and 2 DRY CONDUCTS for HORN and FLASH LIGHT in upper bridge.
Applicable with on/off by key switch, Dimer, Test, and Acknowledge of sound alarm.The acknowledge stop the sound in bridge but not stop the external siren and flash light was that fully controlled from ZH25 MFD in CCR • Visual and sound Alarm of: • Very High Wind Speed • High Wind Speed • low Depth • Very low Depth • Communication Error
