8/9/2019 01 41 00 - Regulatory Requirements
http://slidepdf.com/reader/full/01-41-00-regulatory-requirements 1/4
Toronto Transit
Commission
CONTRACT A29-1
Section 01 41 0
REGULATORY REQUIREMENTS
Page
1 CODES AND STANDARDS
1 1
General:
1 Contract forms, codes, Specifications, standards, manuals, and installation, application an
maintenance instructions referred to in the Specifications, unless otherwise specified an
unless otherwise stated
in
the governing building code, shall be the
latest
publishe
editions at the date of the Contractor s Tender submission
2 Conform to Contract forms, codes, Specifications, standards, manuals, and installation
application and maintenance instructions referred to in the Specifications, in whole
or
i
part, as specifically stated
in
the Specifications
3
In case of conflict between individual requirements, comply with the most demanding an
stringent requirement.
4 If there is a question regarding whether any Product or system is
in conformance
wit
applicable requirements, the Commission reserves the right to have such
Products o
systems tested at the Contractor s cost to prove or disprove conformance
5
The cost for testing will be borne by the Commission in the event of conformance with the
Contract Documents, or by the Contractor in the event of non-conformance.
1 2
Definitions:
1
Refer to the Contract Documents and the Ontario Building Code for definitions applicable to
the Contract.
1 3 Acronyms:
1
Refer to the Ontario Building Code and to the following list for descriptions
o
acronym
applicable to the Contract Documents.
AABC
AAMA
ABMA
AREMA
ASHTO
ACI
ASME
ADA
ACNBC
AFBMA
AHRI
AlEE
A SI
AMCA
AMEU
ANSI
APTA
Aluminum Association
Associated Air Balance Council
American Architectural Manufacturers Association (USA)
American Bearing Manufacturers Association
American Railway Engineering and Maintenance-of-Way Association
American Association of State Highway and Transportation Officials
American Concrete Institute
American Society of Mechanical Engineers
Americans with Disabilities Act
Associate Committee of the National Building Code
Anti-Friction Bearing Manufacturer s Association
Air-Conditioning, Heating, and Refrigeration Institute
American Institute of Electrical Engineers
American Iron and Steel Institute
Air Moving Conditioning Association
Association of Municipal Electric Utilities
American National Standards Institute
The American Public Transportation Association
8/9/2019 01 41 00 - Regulatory Requirements
http://slidepdf.com/reader/full/01-41-00-regulatory-requirements 2/4
Section
141
REGULATORY REQUIREMENTS
Page2
Toronto Transit Commission
CONTRACT A29 1
AREA
ARI
ASH RAE
ASME
ASPE
ASTM
AWMAC
AWS
AWWA
BHMA
CAC
CAN
CCA
eeo
CCMC
CEC
CEMA
CGA
CGSB
CISC
CMHC
CPCA
CPMA
CPCI
CRCA
CSA
es
CSI
CSSBI
CTC
cUL
cULus
CWB
w
EEMAC
ESA
M
FS
GAMA
GANA
HRAI
lAO
American Railway Engineering Association
Air-Conditioning and Refrigeration Institute
American Society
of
Heating, Refrigeration and Air-Conditioning Engineers
American Society of Mechanical Engineers
American Society of Plumbing Engineers
American Society
for
Testing and Materials
Architectural Woodwork Manufacturers Association
of
Canada
American Welding Society
American Water Works Association
Builders Hardware Manufacturers Association
Cement Association of Canada
National Standard of Canada
Canadian Construction Association
Canadian Construction Documents Committee
Canadian Construction Materials Centre
Canadian Electrical Code
Canadian Electrical Manufacturers Association
Canadian Gas Association
Canadian General Standards Board
Canadian Institute
of
Steel Construction
Canada Mortgage and Housing Corporation
Canadian Paint and Coatings Association
Canadian Paint Manufacturers Association
Canadian Precast/Prestressed Concrete Institute
Canadian Roofing Contractors Association
Canadian Standards Association
Construction Specifications Canada
Construction Specifications Institute (USA)
Canadian Sheet Steel Building Institute
Canadian Transport Commission
Underwriters Laboratories classification mark indicating that the Product
has
been evaluated to meet Canadian safety requirements
Underwriters Laboratories classification mark indicating that the Product has
been evaluated to meet both Canadian and
US
safety requirements
Canadian Welding Bureau
Canadian Wood Council
Electrical and Electronic Manufacturers Association of Canada
Electric Safety Authority
Factory Mutual
Federal Specifications and/or Federal Standards (USA)
Gas Appliance Manufacturers Association
Glass Association of North America
Heating, Refrigerating and Air-Conditioning Institute of Canada
Insurance Advisory Organization of Canada
8/9/2019 01 41 00 - Regulatory Requirements
http://slidepdf.com/reader/full/01-41-00-regulatory-requirements 3/4
Toronto Transit Commission
CONTRACT A29-1
Section 1 41 0
REGULATORY REQUIREMENTS
Page
IEC
IEEE
ISA
ISO
MIL
MPI
MOE
MSS
MTO
NAAMM
NBC
NEBB
NEMA
NETA
NFC
NFPA
NHLA
NICEIC
NLGA
NRC
NSC
OBC
OESC
OFC
OFM
OH
OHBDC
OHSA
OIRCA
OPCA
OPSS
OTM
OWRA
PAL CAN
PEl
PEO
sec
SJI
SMACNA
SSPC
TEMA
TRCA
TTMAC
TS
TSSA
International Electrotechnical Commission
Institute of Electrical and Electronic Engineers
Instrumentation Society
of
America
International Organization for Standardization
Military Specifications (Naval Publications and Forms Centre) USA)
Master Painters Institute
Ontario Ministry
of
the Environment
Manufacturer s Standardization Society
Ministry of Transportation Ontario
National Association of Architectural Metal Manufacturers
National Building Code
National Environmental Balancing Bureau
National Electrical Manufacturer s Association (USA)
International Electrical Testing Association (USA)
National Fire Code
of
Canada
National Fire Protection Association
National Hardwood Lumber Association (USA)
National Inspection Council for Electrical Installation Contracting
National Lumber Grades Authority
National Research Council
of
Canada
National Standards
of
Canada
Ontario Building Code
Ontario Electrical Safety Code
Ontario Fire Code
Ontario Fire Marshal
Ontario Hydro
Ontario Highway Bridge Design Code
Occupational Health and Safety Act and Regulations for Construction Projects.
Ontario Industrial Roofing Contractors Association
Ontario Painting Contractors Association
Ontario Provincial Standard Specification
Ontario Traffic Manual
Ontario Water Resources Act
Program for the Accreditation of Laboratories - Canada
Porcelain Enamel Institute
Professional Engineers of Ontario
Standards Council
of
Canada
Steel Joist Institute
Sheet Metal and Air-Conditioning Contractors National Association
Steel Structures Painting Council
Tubular Exchange Manufacturer s Association
Toronto Regional Conservation Authority
Terrazzo, Tile and Marble Association of Canada
City
of
Toronto Transportation Services
Technical Standards and Safety Authority
8/9/2019 01 41 00 - Regulatory Requirements
http://slidepdf.com/reader/full/01-41-00-regulatory-requirements 4/4
Section 0141 00
REGULATORY REQUIREMENTS
Page
ULC Underwriters Laboratories of Canada
UL Underwriters Laboratories (USA)
WHI lntertek (Warnock Hersey)
END OF SECTION
Toronto
Transit
Commission
CONTRACT A29-1