+12V Constant =
+12v Acc. Switched =
-12V Chassis Ground =
+12V Illumination =
+12V Dimmer =
Amp Remote =
LF+ =
LF- =
RF+ =
RF- =
LR+ =
LR- =
RR+=
Dash Type :
Kit:Harness:Antenna Adapter: MDA-1
Interface Adapter(s): GM09BOnstar w/Bose: GMOS2B11Onstar w/Non-Bose: GMOS210Chime Module: GMCM2B12
About the Vehicle
Make: HUMMER
Model: H2
Year: 2003
In Dash Application
Wire Color Codes
Speaker Notes
Front Speaker Sizes
Speaker Adapter : N/A
Factory Assembly: Plastic housing with mounting tabs.
Rear
H2HUMMER
2003
DIN AND A HALF
GM1583
GM06
RR- =
Factory Assembly : Plastic housing with (2) 7mm bolts.
Lower Door : 5 1/4" Midrange
Speaker Sizes
Dimensions:
Dimensions: W= 4 3/4'' L= 4 3/4''D= 4''
NOTES
Rear Door : 5 1/4"Midbass Rear Pillar: 2 1/2''
OPTIONS
ONSTARBOSE PREMIUM SystemCD CHANGER
AMPLIFIER LOCATIONS: Located under the center console.Also the amp is a 6-channel amp.
Aftermarket Kit: SINGLE DIN
W=L= D=
Front Pillar: 1'' Tweeter
NOTES
Speaker adapter fits most 5 1/4'' to 6 1/2''
HUMMER2003 H2
Images
Front Speaker
1. Extract (1) Phillips screw from door handle access area and remove door handle sub-panel.2. Remove Hex screws from behind door handle access panel.3. Use panel removal tool to carefully pry out on panel fasteners to remove panel.4. Press down on tab to unsnap door speaker, unplug and remove.
1. Extract (1) Phillips screw from door handle access area and remove door handle sub-panel.2. Remove Hex screws from behind door handle access panel.3. Use panel removal tool to carefully pry out on panel fasteners to remove panel.4. Extract (3) screws holding speaker, unplug and remove
Radio removal
Front speaker
Rear speaker
1. Open center console storage and extract 4 screws securing hinged lid.2. Remove Torx lock nut holding Shift lever (Nut is facing forward) and Slide shift lever off.3. Use a panel removal tool to carefully pop up cup holder/gear indicator plate.4. Extract (2) 7mm hex screws at bottom of center dash bezel (revealed in previous step).5. Extract (2) 7mm hex screws from center dash bezel (near each vent).6. Carefully pry out on center dash bezel to unsnap, unplug and remove.7. Extract (3) 7mm hex screws holding radio, unplug and remove.
Radio
Rear Speaker
HUMMER2003 H2
Images
Front ''A'' Pillar
Rear ''D'' Pillar1. Use panel removal tool to carefully pry out on panel fasteners to remove panel.2. Unplug speaker and and remove the assembly.
1. Open center console storage and extract (4) screws securing lid. 2. Remove Torx lock nut holding Shift lever (Nut is facing forward) and Slide shift lever off. 3. Use a panel removal tool to carefully pop up cup holder/gear indicator plate 4. Remove 3 screws from rear console trim panel: (1) at top and (2) from recessed area.5. Unplug electrical connectors and remove rear console trim panel.6. Extract (4) screws holding storage bin and remove bin.7. Carfully pull up and remove top console panel.8. Extract (5) bolts holding center console and remove console.
Front ''A'' Pillar
Rear ''D'' Pillar
Center Console
1. Pull away door seal moulding along A pillar trim panel.2. Use a panel tool or flat blade screwdriver to pop out (2) fasteners holding grab handle.3. Use panel removal tool to carefully pry out and release A pillar trim, unplug speaker and remove trim
Center Console