Making A Chic Bead and Chain Fringe Necklace3 Easy Steps
Here is a simple yet fabulous necklace pattern among diversified bead and chain necklace designs. In it, I’ll show you the way making a chain fringe necklace on the base of a beaded link necklace.
Supplies needed in the necklace design:
12mm Jade Beads
Bronze Twisted Chains
Bronze Cross Chains
Eyepins
Jumprings
Lobster Claw Clasp
Wire Cutter Pliers
Round Nose Pliers
Side Cutting Pliers
How to make the bead and chain necklace?
1st, take an eyepin and slide one 12mm jade bead. Make a simple loop above the bead;
2nd, in my design, 13 beaded units are required;
Step 1: Prepare the beaded units and chain segments
How to make the bead and chain necklace?
3rd, cut 12 pieces of chain segments to approximately 15cm (an eyepin may help the chain segments be more neat).
How to make the bead and chain necklace?
Step 2: Decide the beaded pattern and add the chain segments
1st, arrange the 13 beaded units in an desired order;
2nd, open the left loop of bead unit#1 and then slide one chain. Close the loop;
How to make the bead and chain necklace?
3rd, open one jumpring, then string the other loop of bead unit#1, one new chain and the left loop of the bead unit#2. Close the jumpring;
4th, open one jumpring, then string the other loop of the bead unit#2, the last link of firstly added chain, one new chain and the left loop of bead unit#3. Close the jumpring;
How to make the bead and chain necklace?
5th, open one jumpring, then string the other loop of the bead unit#3, the last link of the 2rd chain, one new chain and the left loop of bead unit#3. Close the jumpring;
6th, open the jumpring, then string the beaded units and chain segments in the same rule until the bead unit#12;
How to make the bead and chain necklace?
7th, while connect the bead unit#12 and bead unit#13, you won’t need to add new chain any more.
How to make the bead and chain necklace?
Step 3: Complete the necklace and attach the clasp
1st, cut two 40cm piece of twisted chain;
2nd, attach one jumpring at the left side of first bead loop and then pass the two chains through it;
3rd, gather the last links of 4 chains with another jumpring;
4th, attach the clasp at the last bead unit by using jumpring;
Final