400C67 CUSTOM 2011-2016 FORD 6.7 POWER STROKE PROGRAMMER
Quick Reference Guide
IMPORTANT NOTE
The installation process if very easy and should nottake long for programming and installation to beaccomplished. To speed and streamline the installation,follow these recommendations.
It is very important in the programming process that thevehicle’s battery is fully charged and you DO NOT havea drain on the battery.
Once the programming cable has been connected to thevehicle’s diagnostic port and to the programmer,DO NOT remove or disturb the cable during the ENTIREprogramming process. Only remove the cable from thediagnostic port when the installation is complete.
DO NOT leave the vehicle during programming.The programmer screen will display instructions for youto follow i.e., turning the key to the On position (but NOTstarting the engine), and you will be asked to selectcertain engine tuning and vehicle adjustment features.
During the installation and programming if an errorshould occur, a help number will be displayed on theprogrammer screen. Write down the error message andcontact the tech support team on the providedtelephone number from 9am-6pm, Eastern Time,Monday-Friday.
Step 1 - Plug tuner into vehicle and turn ignition on.
Step 2 - The tuner must read and clear DTCs first beforeentering into programming mode.
Step 3 - Choose your power level/transmission setting.NOTE: See descriptions of different power levels.
Step 4 - If you have larger tires or changed the rear axleratio, select using up and down arrows.
Step 5 - Select whether tire pressure monitor (tpms) isenabled or disabled.
Step 6 - Continue to follow the key on/off prompts tocomplete the installation.
THERE IS A SELECTION OF 5 POWER LEVELS
Stock hp file - Tow full capacity*
Tow file - 40hp/125ft-lbs tq - Tow up to 20k lbs*
Street file - 80hp/235ft-lbs tq - Tow up to 12k lbs*
Performance file - 120hp/440ft-lbs tq** - Tow up to 4k lbs*
Extreme file - 180hp/500ft-lbs tq** - Towing is NOTrecommended with the Extreme file
* These are recommended towing capacities.While towing, try not to race the truck or take off fastfrom a stop. Use common sense.
** Level 3 (Performance) and level 4 (Extreme) require acold air intake.
There are 3 transmission levels to choose from, STOCK,STREET, and EXTREME. STOCK or STREET can beused with Stock, Tow, or Street power levels.EXTREME should be used with Performance andExtreme power levels.
PLEASE NOTE - VERY IMPORTANT
See Figures A & B. You will need to unplug EGR connectorsunder the hood. On the passenger side near top of valvecover you will see an orange connector. Unplug that one.Right next to it there is a vacuum actuated valve with a blackconnector, unplug that one (Only on 15-16 trucks). Then onthe front of the engine, in between the engine and radiatorfan shroud, you will see an orange connector. It isunderneath a large tube. Slide back the safety tab and unplug.
Contact us at:407-721-2824 from 9am-6pm, Eastern Time, Mon.-Fri
or email [email protected] #982
Figure A Figure B
