+ All Categories
Transcript
Page 1: Atlas AA200PHD Amplifier - CyberData Corporationfiles.cyberdata.net/...SIP_Paging_Adapter_to_Atlas_AA200PHD_AA40… · DS4-> Line or Mic - Down for Mic Input DIP Switches for Inputs

The IP Endpoint Company

931449A

Atlas AA200PHD Amplifier to SIP Paging Adapter Connections

Atlas AA200PHD Amplifier

Page Port Connections

Pin Description

1 Fault Sense Input (Common).

2 Fault Sense Input (Sense).

3 Positive 600-Ohm Audio Outputa

a.The 600-Ohm audio output of the page port is also suited for interfaces with lower input impedances.

4 Negative 600-Ohm Audio Outputa

5 Audio Ground Reference.

6 Relay Contact - Commonb

b.1 Amp at 30 VDC for continuous loads.

7 Relay Contact - Normally Openb

Notes2-conductor, shielded speaker wire is recommended.

SIP Paging Adapter Connections

+ - +-

Keep as short as possibleShield/Drain Wire Shield/Drain Wire

HiLo

HiLo

Balanced

GENERAL ALERT

CautionEquipment Hazard: All equipment should be powered down prior to making wiring connections and changing switch positions.

DIP Switch for Input 1:DS1 -> Phantom Power- Down for OFFDS2 -> Mute on Signal - Up for OFFDS3 -> Route output to zone 2 - Up for OFFDS4 -> Line or Mic - Down for Mic Input

DIP Switches for Inputs 2 through 4DS1 -> DownDS2 -> DownDS3 -> UpDS4 -> Up

Page 2: Atlas AA200PHD Amplifier - CyberData Corporationfiles.cyberdata.net/...SIP_Paging_Adapter_to_Atlas_AA200PHD_AA40… · DS4-> Line or Mic - Down for Mic Input DIP Switches for Inputs

The IP Endpoint Company

931449A

Atlas AA400PHD Amplifier to SIP Paging Adapter Connections

Atlas AA400PHD Amplifier

Page Port Connections

Pin Description

1 Fault Sense Input (Common).

2 Fault Sense Input (Sense).

3 Positive 600-Ohm Audio Outputa

a.The 600-Ohm audio output of the page port is also suited for interfaces with lower input impedances.

4 Negative 600-Ohm Audio Outputa

5 Audio Ground Reference.

6 Relay Contact - Commonb

b.1 Amp at 30 VDC for continuous loads.

7 Relay Contact - Normally Openb

Notes2-conductor, shielded speaker wire is recommended.

GENERAL ALERT

CautionEquipment Hazard: All equipment should be powered down prior to making wiring connections and changing switch positions.

DIP Switch for Input 1:DS1 -> Phantom Power- Down for OFFDS2 -> Mute on Signal - Up for OFFDS3 -> Route output to zone 2 - Up for OFFDS4 -> Line or Mic - Down for Mic Input

DIP Switches for Inputs 2 through 4DS1 -> DownDS2 -> DownDS3 -> UpDS4 -> Up

SIP Paging Adapter Connections

+ - +-

Keep as short as possibleShield/Drain Wire Shield/Drain Wire

HiLo

HiLo

Balanced


Top Related