This exam was taken on 28-june-2010. I’ve got 93.2%. This my answers in the exam, and PLZ note that questions red colored was wrong answers.
1 Which OSI layer uses the header information to reassemble the data segments into streams?
application layer
network layer
presentation layer
session layer
transport layer
2
Refer to the exhibit. Assume all devices are using default configurations. How many subnets are required to address the topology that is shown?
1
3
4
5
7
3 A user sees the command prompt: Router(config-if)# . What task can be performed at this mode?
Reload the device.
Perform basic tests.
Configure individual interfaces.
Configure individual terminal lines.
4 What information is contained in the header of Layer 3 to help data delivery?
port number
device physical address
destination host logical address
virtual connection identifier
5
Refer to the exhibit. Host A is trying to send data to host E. When host A sends out an ARP request, what response should be received?
00-08-a3-d6-ab-17
00-10-7b-e7-fa-ef
00-0d-88-c7-9a-24
Destination Unreachable from RouterA
6 Well-known services and applications use which range of TCP/UDP port numbers?
0 to 255
0 to 1023
1024 to 49151
49152 to 65535
7 Which TCP/IP model layer creates additional overhead on network resources due to acknowledgments, tracking, and retransmission of data?
internet
transport
application
network access
8
Refer to the exhibit. The diagram represents the process of sending email between clients. Select the list below that correctly identifies the component or protocol used at each numbered stage of the diagram.
1.MUA 2.MDA 3.MTA 4.SMTP 5.MTA 6.POP 7.MDA 8.MUA
1.MUA 2.POP 3.MDA 4.SMTP 5.MTA 6.MDA 7.SMTP 8.MUA
1.MUA 2.POP 3.SMTP 4.MDA 5.MTA 6.SMTP 7.POP 8.MUA
1.MDA 2.SMTP 3.MTA 4.SMTP 5.MTA 6.MUA 7.POP 8.MDA
1.MUA 2.SMTP 3.MTA 4.SMTP 5.MTA 6.MDA 7.POP 8.MUA
9 Which OSI layer addressing is required to route packets between two networks?
Layer 1
Layer 2
Layer 3
Layer 4
10 Which application layer protocol allows administrators to log into a server from remote locations and control a server as though logged in locally?
DNS
FTP
DHCP
SMTP
Telnet
11
Refer to the exhibit. What function does router RT_A need to provide to allow Internet access for hosts in this network?
address translation
DHCP services
ftpd
web server
12
Refer to the exhibit. The serial interface of the router was configured with the use of the commands that are shown. The router cannot ping the router that is directly connected to interface serial 0/0/0. What should the network technician do to solve this problem?
Configure the description at interface serial 0/0/0.
Configure an IP address on interface serial 0/0/0.
Remove the no shutdown command at interface serial 0/0/0
Reboot the router.
13
Refer to the exhibit. Host A is transmitting data to host B. Which address combination will be used as the data leaves the Router1 Fa0/1
interface?
Destination IP: 192.168.72.2 Source MAC: 0007.C2B4.3421
Destination IP: 192.168.10.4 Source MAC: 0030.8596.DE81
Destination IP: 192.168.10.4 Source MAC: 0007.C2B4.3421
Destination IP: 192.168.72.2 Source MAC: 0030.8596.DE81
14
Refer to the exhibit. Which layered network model is shown in the diagram?
Cisco
IETF
OSI
TCP/IP
15 The XMPP protocol applies to which of the listed services?
IP Telephony
World Wide Web
instant messaging
16 Which device should be used for enabling a host to communicate with another host on a different network?
switch
hub
router
host
17
Refer to the exhibit. An employee wants to access the organization intranet from home. Which intermediary device should be used to connect the organization intranet to the Internet to enable this access?
hub
switch
router
wireless access point
18
Refer to the exhibit. Host A sends a frame with the destination MAC address as FFFF.FFFF.FFFF. What action will the switch take for this frame?
It will drop the frame.
It will send the frame back to host A.
It will send the frame to all hosts except host A.
It will forward the frame to the default gateway.
19 What is the effect of using the Router# copy running-config startup-config command on a router?
The contents of ROM will change.
The contents of RAM will change.
The contents of NVRAM will change.
The contents of flash will change.
20 A network technician has made a UTP cable that is terminated as T568A on one end and T568B on the opposite end. What type of cable has been constructed?
patch
console
crossover
straight-through
21 What action is taken by a host on an Ethernet network when the host attempts to contact a remote host on another network?
The packet is sent using the IP and MAC address of the destination host.
The packet is sent using the IP address and MAC address of the default gateway.
The packet is sent using the IP address of the destination host and MAC address of the default gateway.
The packet is sent using the IP address of the default gateway and the MAC address of the destination host.
22
Refer to the exhibit. Host A is able to access resources on the local LAN but is unable to access any resources on the Internet. What is the likely cause of this problem?
The host subnet mask in incorrect.
The network uses private addresses.
The host address is a network address.
The default gateway is on a different subnet from the host.
23
Refer to the exhibit. What three statements are true about the IP configuration that is shown? (Choose three.)
The address that is assigned to the computer represents private addressing.
The computer is unable to communicate outside of the local network.
The network of this computer can have 126 hosts.
The prefix of the computer address is /27.
The IP address that is assigned to the computer is routable on the Internet.
The IP address that is assigned to the computer is a broadcast address.
24
Refer to the exhibit. Host A uses router A as its default gateway. If host A sends an ICMP echo request to 172.16.10.0, what ICMP response will host A receive.
echo reply
source quench
route redirection
destination unreachable
25 Which service is used when the nslookup command is issued on a computer?
FTP
DNS
DHCP
Telnet
26
Refer to the exhibit. Cable A is plugged into the console port on switch S1. What is required on the PC for a network technician to enter the initial configuration on S1?
a terminal emulation program
a web browser
a Telnet client
an FTP client
27
Refer to the exhibit. Host A is configured with the correct IP address for the default gateway of the router R1 FastEthernet0/1 interface. How will a packet that is sent from host A to host B be handled by the devices on the network?
R1 will drop the packet because R1 does not have a specific route in its routing table to the 10.1.1.0/24 network.
R1 will forward the packet to its default gateway, the next hop router R2. R2 will forward the packet to the directly connected network 10.1.1.0/24.R1 will forward the packet to its default gateway, the next hop router R2. R2 will drop the packet because it does not have a default route to network 10.1.1.0/24.R1 will forward the packet to its default gateway, the next hop router R2. R2 will drop the packet because it does not have a route that is learned by a routing protocol to network 10.1.1.0/24.
28 Which password would allow a user to establish a Telnet session with a Cisco device?
VTY password
enable password
console password
enable secret password
29 Which physical component is used to access and perform the initial configuration on a new unconfigured router?
30 A network has grown too large for technicians to configure network addresses and hosts files for name resolution. Which two application
layer services should be added to the server to allow these needs to be satisfied dynamically? (Choose two.)
DNS
FTP
DHCP
HTTP
SMTP
31
Refer to the exhibit. A user wants to access the Internet from the PC. A part of the running configuration of the router is shown. Which default gateway IP address should be configured at the PC to enable this access?
10.1.192.1
10.1.192.2
10.1.192.54
192.31.7.1
32
Refer to the exhibit. When host A sends a frame addressed for host D, which hosts will receive the frame?
only host D
only hosts A and D
only hosts B, C, and D
all hosts
33
Refer to the exhibit. A network technician is trying to determine the correct IP address configuration for Host A. What is a valid configuration for Host A?
IP address: 192.168.100.19; Subnet Mask: 255.255.255.248; Default Gateway: 192.16.1.2
IP address: 192.168.100.20; Subnet Mask: 255.255.255.240; Default Gateway: 192.168.100.17
IP address: 192.168.100.21; Subnet Mask: 255.255.255.248; Default Gateway: 192.168.100.18
IP address: 192.168.100.22; Subnet Mask: 255.255.255.240; Default Gateway: 10.1.1.5
IP address: 192.168.100.30; Subnet Mask: 255.255.255.240; Default Gateway: 192.168.1.1
IP address: 192.168.100.31; Subnet Mask: 255.255.255.240; Default Gateway: 192.168.100.18
34
Refer to the exhibit. Each media link is labeled. What type of cable should be used to connect the different devices?Connection 1 - rollover cableConnection 2 - straight-through cableConnection 3 - crossover cableConnection 1 - crossover cableConnection 2 - rollover cableConnection 3 - crossover cableConnection 1 - straight-through cableConnection 2 - crossover cableConnection 3 - crossover cableConnection 1 - straight-through cableConnection 2 - crossover cableConnection 3 - straight-through cableConnection 1 - crossover cableConnection 2 - straight-through cableConnection 3 - crossover cable
35 What is the consequence of issuing the erase startup-config command in privileged EXEC mode on a Cisco router?
Data stored in RAM will be removed.
Data stored in NVRAM will be erased.
Information in flash memory will be removed.
Flags in the configuration register will be set to 0.
Both the startup-config and the running-config will be erased
36
Refer to the exhibit. Which list refers only to end devices?
D,E,F,G
A,H,B,C
A,D,E,F
A,D,E,G
37
Refer to the exhibit. Which type of network design is shown?
client/server
wide area
dedicated server
peer-to-peer
38 A network technician is tasked with setting up a network for six users, but the users should be able to use their accounts to log on from any of the six computers. What type of network should be used?
workgroup
P2P applications
peer-to-peer network
client-server network
39
Refer to the exhibit. Which option shows the correct topology given the configuration of Router1?
40 What identifies the core software that is stored in flash memory and provides Cisco devices with basic routing and switching functions?
CLI
IOS
running configuration
startup configuration
41
Refer to the exhibit. A host is using NAT to connect to the Internet. Which three IP addresses enable this connection? (Choose three.)
10.1.1.63
10.1.1.37
10.1.1.39
10.1.1.32
10.1.1.60
10.1.1.2
42
Refer to the exhibit. The ping 127.0.0.1 command is issued on the local host. What do the ping results indicate?
The local host can send packets on the local network.
The TCP/IP stack on the local host operates properly.
The local host has full connectivity to the default gateway.
The local host has full connectivity to the remote network.
43 An organization has been assigned network ID 10.10.128.0 and subnet mask 255.255.224.0. Which IP address range can be used for this organization?
10.10.128.0 to 10.10.160.255
10.10.128.0 to 10.10.159.255
10.10.128.0 to 10.10.192.255
10.10.128.0 to 10.10.0.159
10.10.128.0 to 10.10.159.0
44
Refer to the exhibit. A PC is communicating with another PC on a remote network. The two networks are connected by three routers.
Which action will help to identify the path between the hosts?
Use the ipconfig command at the host.
Use the ipconfig/all command at the destination.
Use the tracert command at the host.
Use the ping command at the destination.
45 What is the Cisco IOS?
system software for Cisco devices
Read Only Memory in Cisco devices
non-volatile storage for device configurations
an initial operating system that is used for boot functions
46 Which three IPv4 addresses represent subnet broadcast addresses? (Choose three.)
192.168.4.63 /26
192.168.4.129 /26
192.168.4.191 /26
192.168.4.51 /27
192.168.4.95 /27
192.168.4.221 /27
47
Refer to the exhibit. All routers in the network are configured with the correct IP addresses and routing protocol. Host A sends a packet to host B. Which exhibited steps will be executed on each of the routers in the network?
Routers R1 and R2 execute all six steps.
Routers R1 and R2 execute steps 1, 2, 3, 4, and 6.
Router R1 executes steps 1,2,3,4, and 6. Router R2 executes all six steps.
Router R1 executes all six steps. Router R2 executes steps 1,2,3,4, and 6.
48
Refer to the exhibit. The router of the company failed and was replaced. After the replacement, hosts C and D in the Education office are able to ping each other, but they are unable to access the hosts in the Accounts office. What is the likely cause of the problem?
The IP address at the fa0/0 interface of the router is incorrectly configured.
The subnet mask at the fa0/1 interface of the router is incorrectly entered.
The IP address at the serial interface of the router is incorrectly configured.
The hosts in the Accounts office are not on the same subnet as the hosts in the Education office.
49 Which two functions of the OSI model occur at layer two? (Choose two.)
physical addressing
encoding
routing
cabling
media access control
50 Which exhibit shows the interface that is configured by the command, router(config)# interface serial 0/0/1?