DIY ROCK ‘N’ ROLL HINGES TECH SHEET

NB. Please note that whilst every attempt is made to ensure that these instructions are as clear as possible, we cannot be held responsible for misinterpretation of these instructions or for any subsequent accident or damage caused through mis-fitted parts. 0845 1204582 www.justkampers.com

• In the seatingposition

• In the bedposition

Use the measurements shown for thecorrect fitting of your hinges. make

sure that measurement ‘A’ allows forthe seat back to be rolled into the bedposition.

The sized drawings are given as astarting guide. There are manyvariations in the way the hinge set canbe installed to suit the intended usage.

Instructions for positioning your rock n roll bed hinges

Front ofvehicle

Note: These measurementsare for a guide only but canbe altered to suit yourparticular application.

Rear Floor

Support

28mm

120mm

216mmA

50mm

Seat Panel

FrontPanel

SidePanel

SidePanel

SidePanel

Seat Back