DOT COMPLIANCE SOLUTIONSProducts & Support To Keep Your Vehicles Moving
USA: 866.LAWSON4U (866.529.7664) | Canada: 800.563.1717 | lawsonproducts.com
E1259 V4 (11/19)
Kidde Automotive Fire Extinguisher
3 Triangular Reflectors Kit
Fluid Glow Sticks
Spilfyter Universal Sorbent Kit
Binding Chain Assembly Grade 70
Load Binder Lever Type 9200 lb. Safe Load
Load Hugger® E-Track Assembly, Yellow, 12’ Length
DOT RegulationGeneral requirements for securing loads and cargo are governed by The United Stated Department of Transportation Federal Motor Carrier Safety Administration (DOT FMCSA) Cargo Securement Standard. (393.100-393.136)
SolutionUtilizing the appropriate material handling equipment for the load
Go to lawsonproducts.com/fleet for a Product Information Report on Load Securement
DOT RegulationEach truck, truck tractor and bus must be equipped with warning devices for stopped vehicles except as provided in paragraph (g)* • Three bidirectional emergency
reflective triangles that conform to the requirements of Federal Motor Vehicle Safety Standard No. 125, § 571.125 of this title; or
• At least 6 fusees or 3 liquid-burning flares. The vehicle must have as many additional fusees or liquid-burning flares as are necessary to satisfy the requirements of §392.22
SolutionA kit with reflective triangles and flares
* (g) Restrictions on the use of flame-producing devices. Liquid-burning flares, fusees, oil lanterns, or any signal produced by a flame shall not be carried on any commercial motor vehicle transporting Division 1.1, 1.2, 1.3 (explosives) hazardous materials; any cargo tank motor vehicle used for the transportation of Division 2.1 (flammable gas) or Class 3 (flammable liquid) hazardous materials whether loaded or empty; or any commercial motor vehicle using compressed gas as a motor fuel
DOT/EPA RegulationEPA and the DOT have worked together to develop standards for the transporters of hazardous waste: EPA 40 CFR 263.31Discharge Clean-up - A transporter must clean up any hazardous waste discharge that occurs during transportation or take such action as may be required or approved by Federal, State, or local officials so that the hazardous waste discharge no longer presents a hazard to human health or the environment.
SolutionSpill control products like absorbent pillows, socks, beads, granules and pads
Go to lawsonproducts.com/fleet for a Product Information Report on Spill Containment
PRODUCTS & SUPPORT TO KEEP YOUR VEHICLES MOVING
FIRE EXTINGUISHERS
WARNING DEVICES SPILL CONTROL
LOAD SECUREMENT
DOT RegulationEach truck, truck tractor and bus must be equipped with fire extinguishers (393.95):• A power unit that is used to transport hazardous materials in a quantity that requires placarding must be equipped with a fire extinguisher having an Underwriters’ Laboratories rating of 10 B:C or more.• A power unit that is not used to
transport hazardous materials must be equipped with either
– A fire extinguisher having an Under- writers’ Laboratories rating of 5 B:C or more; or
– Two fire extinguishers, each of which has an Underwriters’ Laboratories rating of 4 B:C or more.
SolutionThe appropriate rated fire extinguisher
with Vehicle Bracket (UL Class Rating 3A:40B:C)
(Packs of 10 sticks) Spilfyter Oil-Only Sorbent Sock
When you see this symbol Find more at lawsonproducts.com
Item No. 81633
Item No. SF10794M10 SF10796M10 SF10795M10
Item No. SF11609
Item No. DH6065
Item No. SF13226
Item No. 1586662
Item No. 26840
Item No. 98662
Spilfyter Universal Sorbent Kit
VEHICLE VISIBILITY
Find over 3,200 moreProducts for Fleet Lighting, Mirrors, Reflectors and Accessories atlawsonproducts.com
Item No. 60176
LED Lamps
Item No. 64037
Item No. 64048
Reflex Reflectors
Item No. 64053
Item No. 99993 Item No. 57989
Conspicuity TapeDOT RegulationEvery lamp, reflex reflector and conspicuity treatment must be permanently attached in the appropriate location and must comply with all applicable requirements prescribed for it by FMVSS/CMVSS 108 (393.11-26)
Solution 1High-intensity reflective tape
Go to lawsonproducts.com/fleet for a Product Information Report on Fleet Lighting
Solution 2Appropriate fleet lighting & spare lamps
Solution 3Appropriate reflex reflectors & spare reflectors
Item No. 12574 Item No. 12573
USA: 866.LAWSON4U (866.529.7664) | Canada: 800.563.1717 | lawsonproducts.com
AIR BRAKE SYSTEM-WEAR & TEAR AIR BRAKE SYSTEM-CHAFFING & KINKING
SPARE FUSES
DOT COMPLIANCE SOLUTIONS
DOT RegulationEach truck, truck tractor and bus must be equipped with spare fuses (393.95)
SolutionCarrying a variety of spare automotive fuses
Automotive Fuses Find hundreds more automotive fuses at lawsonproducts.com
In-Field Repair Air Brake Hose End Fitting Assembly Kit
Lawson Air Brake System Parts Chaf-Pruf Two Hole Air Hose Clamps w/ Vehicle Bracket
Lawson Air Brake System Parts Air Hose Support Springs
Lawson Air Brake Tubing N-2
Complete Offering Of Automotive Fuses
DOT RegulationAir brake systems need to be secured against chaffing, kinking, or other mechanical damage. (393.45)
SolutionUse air hose clamps and springs to reduce chaffing during operation
Air Brake FittingsFind over 5,200 air brake system products in our Fleet Fluid Power section at lawsonproducts.com
DOT RegulationBrake tubing and hose must be long and flexible enough to accommodate without damage all normal motions of the parts to which it is attached. (393.45)
SolutionAir brake components to repair damage in the field and maintain the system back at the shop
Keep extra tubing and the In-Field Repair Kit for emergencies
Air Brakes System Parts Find over 5,200 air brake system products in our Fleet Fluid Power section at lawsonproducts.com
Printers & Label Makers Find over 100 types of printers and labels at lawsonproducts.com
DOT RegulationThe National Highway Traffic Safety Administration places responsibility for labeling an air brake hose assembly in the hands of the assembler of the hose assembly (49 CFR 571.106). (Not the manufacturer of the hose or hose ends.) Each crimped air brake hose assembly must be labeled.
SolutionHave a labeling system on-site to create your own custom hose assembly labels
Go to lawsonproducts.com/fleet for a Product Information Report on labeling crimped DOT hose assemblies
AIR BRAKE SYSTEM-LABELING
®© 2020 Lawson Products, Inc. All rights reserved. Printed in the USA.
Item No. 1674
Item No. 88874
Item No. 52497Item No. 1675
Push-to-Connect Air Brake FittingItem Nos. 55305 & 28979
Go to lawsonproducts.com/fleet to see more product solutions.USA: 866.LAWSON4U (866.529.7664) Canada: 800.563.1717 lawsonproducts.com
Item No. SF16775
BMP™ 71 Label Printer