EXTERNAL REARVIEW MIRROR MAINTENACE
Tools needed-Rubber Hammer.-5mm long-rod hex-key.-Ratchet hex key with 8mm sockets.
Remove the fixation lock from the mirror’s arm.
To remove the mirror’s arm, push up the arm with both hands.
Find the locking-bolt at the lower side of of the mirror’s arm.
Free the lockjng-bolt with the long-rod hex key.
Separate the conectors of the eletrical motor and anti-fog circuit.
Move the upper side of the mirror in, show ing the mirror’s fixing lock in it’s lower side.
With the help of a screwdriver, push the lock in and down, to make possible the removal of the mirror.
Once lifted the lower side, move the mirror downward to remove it.
The mirrors has a anti-fog circuit fed by two conector wich must be desconected in order to remove the mirror.
Repeat the same explained steps to remove the auxiliar mirror.
DRIVEMOTOR REMOVAL
Locate the three piilips bolts on the mirror support and free them to remove the support.
After remove the mirrors’s pad, we have acces to the mirror’s drivemotor.
To remove the drivemotor, free the four bolts located behind it, using the long-rod hex key.
Before reassembly the mirror, inspect the mounting bracket for possible damage or cracks.
CHANGING THE MIRROR’S MOUNTING BRACKET
Find the four m8 bolts on the mounting bracket of the mirror’s arm.
To remove the mounting bracket remove the four bolts using the long-rod hex-key.
It is very important that after every mirror removal a new layer of seal tape be applied in the indicated region to prevent vibrations between the body and the arm.
APLICACIÓN DE CINTA ADHESIVA DE ESPUMA
Apply the seal tape in the mirror’s arm as indicated in the pictures.