Fuse Replacement
1. Make sure the bed is in the fully flat posi7on. 2. Insure the bed is not plugged into and electric outlet or power strip. 3. Turn the bed over on it side or on its back. 4. Locate the Power Supply/Control Box (figure 1)
Figure 1: Power Supply/ Control Box
Figure 2: Fuse Holder on Power Supply/Control Box
Fuse Holder
5. Find the fuse holder and remove it with a flat 7p screwdriver. (Figure 2) 6. Remove the Fuse. 7. Replace the fuse with a 1 AMP 250V Slow Blow Fuse. 8. Reverse to install.
NOTE: DO NOT OVERTIGHTEN THE FUSE HOLDER