+ All Categories
Transcript
Page 1: HOLD ME ROPE ANCHOR - Lifting and Rigging Equipment · RIGGING APPLICATIONS "Hold-Me" rigged with wire rope choker around anchor point "h" and connector shackle attached to hole #6

Part# Description Weight

01300 Hold Me Rope Anchor 0.50

accessories

GUARDIAN FALL PROTECTION I www.guardianfall.com I (800) 466.6385 accessories I 197

HOLD ME ROPE ANCHOR

Hold Me Rope Anchor m• Convenient lifeline connection point• Safer than tying a knot• Reusable lightweight aluminum• Easy instructions for tie off• Stays taut, but simple to untie• Attach carabiner to top hole for attachment to anchor point

Dimensions: 10”(L) x 2”(W) x 5/16”(H)Holes: 1” (D)Material: 70.75 T6 Aluminum

2 VLL Anchorage

Vertical lifelines with rope grabs are a common use for this anchor.

3 Anchor Termination

Can be used as a termination at the end of a rope to add an anchor point.

1 Tie Back

Can be used to choke off around a nonabrasive support member when a permanent anchor point is not available.

Page 2: HOLD ME ROPE ANCHOR - Lifting and Rigging Equipment · RIGGING APPLICATIONS "Hold-Me" rigged with wire rope choker around anchor point "h" and connector shackle attached to hole #6
Page 3: HOLD ME ROPE ANCHOR - Lifting and Rigging Equipment · RIGGING APPLICATIONS "Hold-Me" rigged with wire rope choker around anchor point "h" and connector shackle attached to hole #6

Top Related