How to Fold an Origami DiplodocusStep 1
Gather a square piece of origami paper.
Step 2
Fold the bottom corner of your model up to the top corner. Crease well and unfold.
Step 3
Fold the right corner of your model over to the left. Crease well and unfold.
Step 4
Turn your paper over and rotate it 45 degrees. Then fold the top edge of your model down to the bottom.
Step 5
Then fold the left corner of your model over to the right. Crease well and unfold.
Step 6
Rotate your model so it looks like a diamond. Then fold the top and side corners down to the bottom corner.
Step 7
Then fold the bottom side edges of your model to the center vertical crease.
Step 8
Then turn your paper over and repeat.
Step 9
Then fold the top corner of your model down.
Step 10
Now fold the top layer of the bottom corner of your model up and squash down the sides.
Step 11
Turn your model over and repeat step 9.
Step 12
Repeat step 10.
Step 13
Fold the inner bottom corners of your model outwards. Then fold the top corners down.
Step 14
Rotate your model 180 degrees. Then fold the top corner of your model over to the left.
Step 15
Then fold the top corner to the right.
Step 16
Turn your model over and repeat the two previous steps.
Step 17
Open up your model from the bottom.
Step 18
Then fold the left corner of your model over to the right.
Step 19
Now fold the bottom edge of the small triangle in the middle of your model up so that it aligns with the left edge.
Step 20
Now fold the small triangle over to the left.
Step 21
Now fold the edges of the tail to the center horizontal crease.
Step 22
Fold your model in half.
Step 23
Now fold the back corner of your model over so it overlaps the front part of your model.
Step 24
Now fold the front legs of your model down.
Step 25
Fold the front legs of your model in half.
Step 26
Fold the bottom edge of your model into the rest of the model.
Step 27
Fold the right corner of your model down.
Step 28
Fold the right edge of your model over to the left.
Step 29
Now fold the right edge of your model all the way to the left.
Step 30
Now fold the bottom corner of your model up.
Step 31
Now fold the top corner of your model over to the right. After that your diplodocus is finished.